Another one for Steve
Mike Foster
Latest diatom. I saw the diatom and immediately envisaged how I could possible turn it, so was hooked. It was a bit more complicated to complete than other pieces that I could turn like a box. Rather than turn tenons on it I cut a blank where the join would be and glued it back together with a paper joint. I then turned the shape (described below) using 6 different mountings. I separated the piece, and turned the shapes on top and bottom and got everything as near to 1/8" as I could. I had to hollow the points with carving tools to get them to the same thickness. Once hollowed, the piece was re-glued and then pierced and carved. I love how doing these things really pushes my limits in figuring out how to go about them.
The last two photos show how I mounted the piece to turn the outside. Now I could have done this much easier by using a bandsaw to shape it, but what fun is that? It was a little daunting to turn those inside curves. Not at all like turning a multiaxis spindle. Here you have the whole blank spinning around and coming to meet the tool. Requires total attention and concentration even using a boring bar setup. It would be real easy to get the cutter too deep in the air space and have that blank wham it next trip around.




