Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Personalized Wooden Watches, Engraved Free

McNaughton Micro Center Saver

Posts

McNaughton Micro Center Saver

#1

McNaughton Micro Center Saver

Tom

Anyone out there have experience with the McNaughton Micro Center Saver system with respect to coring small bowls in dry wood?

Is it only good for coring in green wood? Santa left a system for me and would like some advice/insights into using same?

Many thanks! Tom

Re: McNaughton Micro Center Saver

#2

Re: McNaughton Micro Center Saver

Dave in Alaska

I have the standard set for my big lathe and the Micro for my Vickmark 100 lathe. On the advice of Craft Supplies, I ended up with the Micro. I had totally trashed the set within two or three bowls. Sure, it was dry wood. But look at the knives and the flimsyness is pretty apparent. I can't recommend the Micro. Look to see if you can upgrade to the Mini at least.

Re: McNaughton Micro Center Saver

#3

Harry Robinette

Re: McNaughton Micro Center Saver

Harry Robinette

I have the Large,Standard and mini sets and love them.I've heard some not so good comments about the Micro set. I'd try to upgrade to the Mini. Cored out 5 sets 6 and 7 ' 3 bowls each with the Mini.on 1hp lathe and had power left over.

Re: McNaughton Micro Center Saver

#4

Re: McNaughton Micro Center Saver

Tom

Is it essential to only turn wet wood with either the micro or the mini?

Re: McNaughton Micro Center Saver

#5

Re: McNaughton Micro Center Saver

Carole Valentine

No, you can turn either. By it's very nature the micro must be a thin blade with a thin kerf and therefore takes a very gentle touch. You cannot force the tool. You might try Steven D. Russell's pulse method which he describes on his site. If you have the micro-post you can use either the micro or small/mini blades. The small/minis are more substantial but create a correspondingly larger kerf.

Re: McNaughton Micro Center Saver

#6

Re: McNaughton Micro Center Saver

Tom

Thanks to all for your responses/advice. Looks like I'll be ordering the mini blades!

Woodcentral is really great for getting help!!

Tx

Tom

Re: McNaughton Micro Center Saver

#7

Re: McNaughton Micro Center Saver

Carole Valentine

It's best to have both anyway, unless you are strictly into doing miniatures. And even if you eventually go with a full size system on a big lathe, don't throw your micros away...they are great for those smallest little bowls in a set. Just be gentle with them. I used the micro just yesterday to take out the smallest bowl in a 7 1/2" set, then moved to the small blades for the rest. Have fun!

Re: McNaughton Micro Center Saver

#8

Re: McNaughton Micro Center Saver

robo hippy

If your set is trashed in a few cores, you might be using them too hard. They are delicate, and will bend with use, just like the bigger blades can. You can easily bend them back into shape. You will need a circle template, one of the clear plastic ones, that you can lay the blades over, or even pencil lines on paper. The blades will tend to twist a bit, and you can torque them back till they lay flat on a work bench.

robo hippy

Re: McNaughton Micro Center Saver

#9

Re: McNaughton Micro Center Saver

Tom

Many thanks again! All these tips are really appreciated!! My Mini set should be here in a few days!

Tom