Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Compare cordless drills on the numbers that matter

Tool rest support mechanism upgrade help.

Posts

Tool rest support mechanism upgrade help.

#1

Tool rest support mechanism upgrade help.

Ray Carson - Lawrenceville, NJ

I'm looking for possibly upgrading (somehow) the tool rest support mechanism on my Grizzly G0462 lathe. If I can't, I'm looking for some optional tool rests. I've already looked at Craft Supply, Penn Industries and naturally Grizzly. Any others?

Re: Tool rest support mechanism upgrade help.

#2

Re: Tool rest support mechanism upgrade help.

Jim H

On the actual tool rest, I don’t think you can beat Robust rests. They have a hardened rod on top that makes for very smooth tool movement, and come in different post diameters to fit many lathes.

If you are needing to replace the Banjo, I’ve been told Oneway’s are exceptional (you will have to check compatibility with Grizzly), but all I have is a Jet Midi so what do I know. :D

Re: Tool rest support mechanism upgrade help.

#3

Leo Cuellar

Re: Tool rest support mechanism upgrade help.

Leo Cuellar

Hi Ray,

The G0462 has an oddball size for the post.I drilled mine out to 1" then made the different rests that I wanted. You could also retrofit an entire banjo assembly from another lathe. The main thing to watch for there would be that the bolt that clamps it to the ways is long enough to do the same.

Re: Tool rest support mechanism upgrade help.

#4

"Learn something new everyday"

Ray Carson - Lawrenceville, NJ

I didn't know the support was called a "banjo." Maybe a search for that word will come up with better results. Good to know about the G0462 also.

Thanks Leo.

Ray

Re: Tool rest support mechanism upgrade help.

#5

Lyle Jamieson

Re: "Learn something new everyday"

Lyle Jamieson

Its called a banjo because in the good old days before the cam action rests there was a slotted hole through the tool rest base with a bolt through it, to hold it to the bed. The back end of the tool rest slot there was a larger hole so the spindle turners could remove/replace the tool rest base without the need to slide it down the end of the ways. (By the way this is the same reason there are lathes with a gap at the headstock) The nut/bolt head could slide down to the end of the slot and poke through the hole. Thus the casting for the tool rest base was banjo shaped.