Earlier this week I spent an hour doing "food prep" on my Jet 1642 for our woodworkers potluck dinner on Monday evening.
I thought you might like to see one of the things I brought to our dinner:
Carrots were held in a Vicmarc VM100 with extended jaws, and the tailtock end supported with a Oneway live center while truing to round. A 3/8" spindle gouge worked best. First ones took about 2-3 minutes each; after the rhythm was going, each subsequent tree took about 45 seconds each. No sharpening of the gouge was needed between forms....
It took almost as long to clean-up the lathe than it did to turn 5 pounds of carrots.
Since there were so many wives present at the dinner, I made the announcement that lathes can also be used for special food preparation. Not sure how many guys in our club will try this, but at least a few thought this was kind of neat; others thought I was out of my mind.
Rob: You have a lot of guts telling the ladies to make the men do the peeling.
I use the lathe for peeling because that is the only way I can get fresh turnips and rutabagas. Part of the bonus of having a "non-peeling" wife.
To help with the clean up at the lathe I use several 50 gal. trash bags draped over anything that is vulnerable. I also wash off the face shield intermediately, otherwise the vegetable juices are hard to clean off.
Rob, I would be careful at your next club meeting if I were you. There may some of your fellow turners who's wives want them to juice up their lathes turning food. They may not be too happy.