Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Have a question? Ask Woody!

One Way Question

Posts

One Way Question

#1

One Way Question

Lewis Dodd

I have a 2436 and was watching a friend yesterday on his 2436. My habit on my machine is to stop it then switch to reverse and restart it. He switched to reverse with the machine still running. I asked him about this, as to whether it was good or bad on the system. He said he had never thought about it and has been doing it since he got the machine. Any advice, opinions, or thoughts on this?

Re: One Way Question

#2

Re: One Way Question

robo hippy

The phase converters are smarter than we are, kind of like the new cars that turn off your head lights for you when you forget. When you switch from forward to reverse, the electronic brake kicks in first, then after the lathe stops, the reverse kicks in. When I do this, I am always at slow speeds, less than 50 rpm.

robo hippy

Re: One Way Question

#3

Right from the owners manual

Galen Vetterick

"Flipping the switch while the lathe is running will cause the lathe to decelerate

to 0 rpm and then re-accelerate in the opposite direction to the selected speed.

Changing the direction of the rotation while the lathe is running will not harm

the motor or the drive, but accessories can unscrew if not locked to the spindle"

Re: One Way Question

#4

Re: Right from the owners manual

Lewis Dodd

Hey thanks guys! I bought my Oneway new from Eagle Tools in Ca. but never got an owneers manual.

Guess I have just been putting more wear on the on and off switches...seemed like the prudent "self taught" thing to do to me.

Re: One Way Question

#5

Dennis in Southern Oregon

Re: Right from the owners manual *LINK*

Dennis in Southern Oregon

Here is a link to the Oneway site where you can download a manual.

Dennis


http://www.oneway.ca/pdf/2436_manual.pdf

Re: One Way Question

#6

Powermatic 3520B- same question?!

Randy Gleckler

Is the same true for the Powermatic does anyone know? I follow the same process of shutting it off, then switching to reverse then back on.

Re: One Way Question

#8

Re: Powermatic 3520B- same question?!

John Lucas

Well I have the 3520A and you can switch it to reverse while running. I does exactly what was mentioned above. If you start the lathe with the tool rest blocking the wood it will not start also. You don't need to know how I know that.

My aftermarket VFD that I installed on my Nova 3000 also did the same thing. That must be a feature that is one of the many options you can set on those gadgets.

Re: One Way Question

#9

Warning about VFD's

Steve Mushinski

You are all correct that there is no problem switching from forward to reverse without stopping. One thing you might wish to think about it doing to too often in a short time period. The energy (heat) that the breaking causes has to go somewhere and that is a resistor built in the controller. If you are doing a lot of starts and stops, it is recommended that an external breaking resistor be used.

Where I am going with this, yes you can do it, and it will work for many years. If you do it often and heat up the built in breaking circuit you will shorten the life of the controller without the use of the external resistor.

For most of us hobby turners it is of no concern. Turners running the lathe everyday with lots of stops you might wish to add the breaking resistor.

Merry Christmas