Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Exotic Hardwood, Personally Sourced Worldwide. Inspected at Origin. Shop Rare Stock.

pepper mill finishes

Posts

pepper mill finishes

#1

pepper mill finishes

Eric in Los Gatos

Well, I'm into my pepper grinders for Christmas gifts and have discovered interesting things like you can drill long mills from one side but even with the really good bit and extension there is some runout so the hole on the far end is off center. Only took me two blanks to figure that one out. Funny that none of the videos I watched mention this. Ah well. At least my steady rest based on Dominic Greco's design is working out.

So now that I'm making progress I'm thinking about finishes and wonder what all y'alls preferences are. I'm thinking either minimalist like BLO or (real tung) or a film finish. I do have some really nice wood and want the beauty to come through but since these will, of course, be handled a lot I'm not at all sure what to use.

Any thoughts?

Thanks,

Eric in Los Gatos

Re: pepper mill finishes

#2

Jim Evans

Re: pepper mill finishes

Jim Evans

Depending on the wood I use BLO with WOP or just WOP by itself. I tried lacquer but the finish doesn't seem to be as tolerant to handling as WOP.

Re: pepper mill finishes

#3

Re: pepper mill finishes

Steve Criscenzo

Eric

As I noted in my post below, I drill my pepper mills from both ends so there are no alignment problems.

I finish my mills with thin CA. After sanding on the lathe, I put on a thin coat of CA. Wait a minute and spray with accelerator then repeat. Give it five minutes and sand with 400. I buff with white diamond and then carnuba. Been using one at my house for over a year and it still looks great. Total finish time is 15 min.

Steve.

Re: pepper mill finishes

#4

Re: pepper mill finishes

Bernie Weishapl

I drill my mills from both ends. I drill half way or so then reverse and drill. I use either WOP or Polymerized Tung Oil.

Re: pepper mill finishes

#5

Re: pepper mill finishes

GaryG in MD

A couple coats of Bush Oil, rubbed out to Abralon 4000. Then carnauba wax and Ren. wax. ...Gary

Re: pepper mill finishes

#6

Re: pepper mill finishes

Don Orr

I also drill my mills from both ends before final shaping.

I use Bush Oil like Gary-2 coats-2nd rubbed in with fine 0000 steel wool-then a coat of LV Conservators wax. Nice soft sheen and you can still feel the wood.

Re: pepper mill finishes

#7

Steve Kubien

Re: pepper mill finishes

Steve Kubien

I use Rustoleum's rattle can lacquer and if the wood is softer, I'll used sanding sealer beforehand. Zero issues after years of hard use in a lot of kitchens I know of.

Re: pepper mill finishes

#8

Re: pepper mill finishes

Eric in Los Gatos

Thanks, guys. I'll think I'll try the "rattle can lacquer" with possibly a wash coat of shellac underneath for the ones I have to ship. I'd like to experiment with the oil types later but don't have time if I'm going to get them done in time. Cyanoacrylate could be interesting. I've experimented a bit on pens but seem to be on the steep part of the learning curve.

Eric in Los Gatos