Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Find a woodworking club near you

OT: Firepits

Posts

OT: Firepits

#1

Steven Antonucci

OT: Firepits

steven antonucci

Does anyone here own one of those outdoor metal firepits? I picked one up at Home Depot today and I noticed that it worked OK, but didn't burn as well as my old steel brake drum did. Lots of ash, very smoky...

I was wondering if it might benefit from a couple of small air intake holes underneath. Does anyone here have one that has holes in the pan?

Steve

Re: OT: Firepits

#2

Harry Robinette

Re: OT: Firepits

harry robinette

I don't have one YET.But was told you have to burn them in and keep some ashes in the bottom so the fire will burn better.Didn't make allot of sense to me but I don't have one YET( my other half says next summer).

Re: OT: Firepits

#3

Re: OT: Firepits

Jennifer Indy.USA

We have one and use it several times a week even in chilly weather. Great for morning coffee and wonderful for evening cocktails.


We drilled 3, 1" holes in the bottom of ours for drainage and breathing. We love ours!

Re: OT: Firepits

#4

Re: OT: Firepits

Randy Johnson

Living out in the sticks as I do, I have never needed one of those things. I can do it the old fashioned way. I see a lot of them but I guess I have never really looked at one before.

The need for the holes you describe, due to the reasons you give, seems so obvious that one has to wonder why they are not part of the original design. It’s one of those cases where common sense (of the consumer) might be trumping the much vaunted education (of the designer).

The Tim Allen in me would have a piece of copper tubing fitted to one the holes at one end and to an air hose from the compressor at the other end.

Re: OT: Firepits

#5

Don Leydens

Re: OT: Firepits

Don Leydens

Hi Steve! I bought one last year and use it quite often. Mine was purchased at Lowe's and has a single 3/4" hole in the bottom. There is a small pan underneath to capture any coals that might fall through. It works great and is so nice on a cool night with some friends gathered around.

Re: OT: Firepits

#6

Re: OT: Firepits

Carole Valentine

Hmmm...I think I would be a bit nervous with all those dry leaves around the pit, Jen. Doesn't take much of a spark to set those things off....a small gust of wind, an ember popping from the burning logs, or dropping through the holes. Be careful.

Re: OT: Firepits

#7

Steven Antonucci

Thanks all

steven antonucci

You've confirmed my suspicions. I have no idea who designs these things, but you can tell they weren't a blacksmith in past lives...

I will probably drill a small bunch of 1/4" holes to start. If they need to be bigger, I'll drill them bigger... filling in welds is a lot harder to do!

Steve

Re: OT: Firepits

#8

Re: Thanks all

John Veerkamp

Think about it though. We burn fire in pits in the ground very successfully. There is no hole for air from below and yet they work. Don't think this to death. The "pits" are so shallow that there is plenty of oxygen available. The reason to leave ashes in the bottom is two fold. It helps protect the metal from direct heat of the coals and it helps to keep the coals hotter. The only practical purpose for the hole in the bottom is to let water drain out when there is no fire to prevent premature rusting.

Re: OT: Firepits

#9

Re: OT: Firepits

Pete in Holland MI

Steve -

I built my own fire pit from an old electrical panel from a machine. Current one is 8" deep x 24" x 30". Weld some angle iron on the corners to raise the bottom about 8" off the ground, and some big flat washers to keep it from settling into the lawn. Remove the back panel from the inside of the panel and weld it to the outside bottom of the panel, with some 2" spacers for it to function as a heat shield. I put a pair of steel wheels on it, along with a short handle to pull it around. The door hinge pin is removed and the door serves as a lid to keep the rain out.

These last me 3-4 years.

We have campfires frequently in it. It's portability allows it to be in the front, back, or neighbor's yard. The heat shield protects the grass. It is also the place where I burn up my scrap lumber and turning noodles thru the winter.

In the front yard, it serves as a draw to the neighbors on a Friday night to come over for a beer (BYOB) and just chat for the night. Have had some mighty fires in it over the years, and I encourage all of you to try one out. It does wonders keeping your neighborhood closer together !

Pete