mini live center
john lucas
Well my machinist skills have a long way to go but this was fun. A gentleman needed a faceplate and live center for a Dremel mini lathe. since I have one I knew what they looked like and it seemed like a challenging project to work on my skills. the live center works very well considering that there aren't any bearings. the original had a ball bearing in the bottom of a cup. I didn't have one of those so I rounded over a 1/8" rod and silver soldered it into the bottom of the metal cup. Then hardened this combo and inserted it into the 1/4" connector nut that had been drilled out part way. then I just turned the live center part and inserted it into the connector nut. rounding over the end produced a burr that captures the live center part. Mine doesn't work quite as smooth as theirs but does work. I chucked it up in my big lathe and ran a piece to see. 



