Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Compare cordless drills on the numbers that matter

Epoxy as finish?

Posts

Epoxy as finish?

#1

Epoxy as finish?

Royce Meritt

I am interested in trying epoxy thinned with aceone or lacquer thinner as a finsh. I've read a little about it but have some questions for any of you with experience with it.

1. Mix up the 2 part epoxy in a small container and add the thinner...How much thinner should one use?

2. How long should one let it cure before next coat?

3. Sand between coats?

4. Is the finish gloss, semi-gloss, etc?

Any thoughts? Thanks.

Re: Epoxy as finish?

#3

Chris Groves

Re: Epoxy as finish?

Chris Groves

Both Devco 2 Ton epoxy and Enviro Tex light are commonly used as clear coats (gloss) over turned striped bass plugs made from Cedar, Maple, Birch, an Mahogany. They can be thinned but I prefer to warm up the 2 bottles in warm water prior to mixing them 1:1

The 2 Ton Devco epoxy sets up much faster and does not require a spinner to prevent sags. The Envirotex Light is a thinner product and requires a rotating mechanism to obtain a uniform thickness... it sets up in about 45-60 minutes while the Devco sets up in 15-30 minutes. the working time can be prolonged by mixing on a piece of aluminium foil or on a qt yogurt top as the mixing surface... mix with a 3/8" diameter dowel... it introduces less bubbles... some people use a candle to remove the occasional bubble that may be present... the bubbles are made by the polymerization rxn and a small mt of heat... even your breath will pop the bubbles.

Epoxy is usually applied with an acid brush available in craft stores... to eliminate the troublesome shedding of the bristles ... add a small amt of superglue where the bristles meet the metal handle

I have used epoxy as a finish on small bowls, ice cream scoop handles, and turned and hand carved striper plugs

Re: Epoxy as finish?

#4

Re: Epoxy as finish?

Dinyar Chavda

Mark (or anybody else):

Thanks for the reference. After all these years, I still struggle with finishing!

My question is where Phil refers to "worn" sandpaper. What is that? I don't think that I have ever come across that term before..

TIA.

Re: Epoxy as finish?

#5

Jesper, Denmark

Re: Epoxy as finish?

Jesper, Denmark

Just be aware that epoxy is sensitive to UV light. Depending on the end use of the piece, it may not matter, but anything displayed where sunlight is present is not likely to look good forever.

Re: Epoxy as finish?

#6

Chris Groves

Re: Epoxy as finish?

Chris Groves

Worn sandpaper is just that... the grit is not as aggressive so it will not leave as many scratches behind...

I always have a pile near my lathe of several grits of worn sandpaper.. esp the norton 3X brand... IMHO it does last a lot longer

Chris