Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Have a question? Ask Woody!

deep hollowing setup

Posts

deep hollowing setup

#1

deep hollowing setup

James Pittman

I am thinking about buying a deep hollowing/hollow form setup and I know by what I have seen here that many of the people here have differant setup.I have a 4224 powermatic I would like to hear from you if you were buying a setup what would you buy? I am not trying to start any thing I just do not want to buy a setup and then have to buy another later. Thanks Jim

Re: deep hollowing setup

#2

Re: deep hollowing setup

Greg Haugen

Personally, IF I was going to personally buy a DEEP hollowing system, I like the looks of Brian McEvoy's and really talking with him at the AAW symposium, his demonstration was excellent in the trade show. It is not cheap, but it is one of the biggest. I also like the fact that it is floor mounted and not lathe mounted. No need for extra extensions, etc. http://onegoodturn.ca/ However, Lyle's "Giant" version is pretty incredible as well.

There are many options. There's Lyle Jamieson's, Clark's, Monster's, Oneway's, Steve Sinner's, and Brian McEvoy's and when the marketing is taken out of it, they're all great and would do the job. The best one is the one you buy and USE. Far too often, people voice complaints about a tool or system that they don't use often enough and hence haven't spent the time to learn it.

Re: deep hollowing setup

#3

Re: deep hollowing setup

Joe Meirhaeghe

James.

I guess it really depends on what you consider deep. I have used the system from Advanced Lathe Tools LLC. for almost 4 yrs now. I have hollowed close to 100 vessels now some up to 33" deep with it. Their system is available with several different size boring bars depending on how deep you want to go.. I use a Rolly Munro cutter in my boring bar, this makes it a very efficient system with this cutter head. ( the Rolly Munro cutter head Does Not come with the system.)

Advanced Lathe Tools are available through The Sanding Glove.

Re: deep hollowing setup

#4

Lyle Jamieson

Re: deep hollowing setup

Lyle Jamieson

Thanks for the endorsment. Not too many people go with the bigger systems because they have limitations in what can be done in what would be a normal scale. The people that have the bigger systems always get the standard size boring bar systems first. I have a jumbo bar that fits in the basic system that will reach 15-17 inches deep, without vibration. If you go bigger/stronger then that the entire system has to be beefed up to handle the stresses.

I have to disagree with you on the backrest issue. I want it attached to the lathe for stability. The forces get so intense I dont want the back rest support lifting off the ground or moving on me in the middle of the turning process. I have seen a 200 pound man get lifted right off the ground hollowing. When you get 100-200 pounds of wood spinning around it will not just stop in a heartbeat.