Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Need a tree taken down or milled?

Rolled-in Platter

Posts

Rolled-in Platter

#1

Rolled-in Platter 

Ronnyeelen


This platter is Claro Walnut. Size is 48cm x 6cm (19” x 2.5”, approximately).

It has a rolled-in rim. I decided to that term instead of the previous ‘round rimmed ‘ I used on 2 of my previous bowls. The second picture shows a more detailed view of the edge. The other ones were rolled-in as well. But maybe that was not so clear to everyone. Someone said why don’t you use an undercut, to give some more effect. Hmm, I thought, how could I cut more under than it already is :)

So it was time to try to show it in a more obvious way. And I had to try hard, because it was no real fun to get it right. A hole in the wall tends to make the gouge bounce a lot. And the bigger the hole, the harder the bounce.

Next to the sap wood still visible, was a layer of decayed sapwood, an inch or so thick. It disintegrated into dust immediately when cut. So after the turning I decided to take it off completely.

Of course all comments and critiques are welcome.

Thanks for looking

Ronny


Re: Rolled-in Platter

#2

Nice, I like the rim treatment


Re: Rolled-in Platter

#3

That is gorgeous!  Beautiful!!


Re: Rolled-in Platter

#4

Re: Rolled-in Platter

Scott in Falcon

Nicely done! For some reason, it makes me think of the Cookie Monster. :)

Re: Rolled-in Platter

#5

Don Leydens

Re: Rolled-in Platter

Don Leydens

I really like the grooves you put on the inside of the piece. Nice design idea!

Re: Rolled-in Platter

#6

Re: Rolled-in Platter

ronnyeelen

Thanks all, appreciated

Re: Rolled-in Platter

#7

Outstanding !


Re: Rolled-in Platter

#8

I agree with Thad. - Nice job!

Ray Carson - Lawrenceville, NJ

I like the "broken rim".

Ray