Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Find a woodworking club near you

I hate it when that happens.....

Posts

I hate it when that happens.....

#1

I hate it when that happens.....

Barry Irby

Several years ago I bought a bottles of "remover" or release agent for CA glue. You know, In case I glue my finger to my face or worse. I never opened it because I assumed it was very volatile and would escape when I broke the seal. So today I found a small glob of CA on the formica covered wing on my TS. Tried scraping it, but was ruining the finish on the laminate. So I broke out the emergency bottle of debonder. Put a few drops on the spot and it appeared to work, so I put the lid back on the bottle. The lid is plastic and one of those that covers the little spout. Gave the little extra twist to be sure it was tightly sealed. Crack. The cone or trumpet bell shaped piece of the top broke off. I covered it with foil tape, but I'm guessing that's the end of the debonder. Hate it when that happens.

Suggestions? Freezer? Plastic bag?

Re: I hate it when that happens.....

#2

Re: I hate it when that happens.....

Bart Leetch

Get another bottle with a screw on lid with a good seal. Using ear swabs to apply the release agent works well too.