Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Veritas - Innovation in Tools

How to make off-side neck on weed pot

Posts

How to make off-side neck on weed pot

#1

How to make off-side neck on weed pot

adrien

Some time back I made a weed pot with its neck off center. I brought it to work, had it on my desk for years, but some *bleep* swiped it. I'd like to make another, but can't remember how I did it!

I know how to make a small vase, but how can I make it with the neck off center? :(

Re: How to make off-side neck on weed pot

#2

Re: How to make off-side neck on weed pot

John Veerkamp

Turn the base then move your center to one side, or tilt and only move the tail center and turn the neck.

Re: How to make off-side neck on weed pot

#3

Re: How to make off-side neck on weed pot

John Lucas

When I've done those I turn 2 tenons for my chuck. Put the piece on the lathe between centers and turn a tenon for the main part. You can rough out some of the piece at this stage but leave a large enough area on the neck end to be able to shift it between centers. Shift the piece to align the neck the way you want it and turn another tenon on the bottom. If you only shift the top and not the tenon side you won't tear up the original tenon too much and there will be enough wood to grip either tenon for your final turning.

Re: How to make off-side neck on weed pot

#4

Re: How to make off-side neck on weed pot

bernie feinerman

You need 2 mounting methods on the "bottom". One method is to make 2 tenons which works.

I think another method, which might be easier is, to use 2 holes in the base for screw chuck mounting, a center hole for the main turning, and an offset hole for the reminder of the turning.

Bernie