Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Identify and use hundreds of woods

Keeping Holly from looking dirty

Posts

Keeping Holly from looking dirty

#1

George Taylor

Keeping Holly from looking dirty

George Taylor

In order to try a new design for wine stopper blanks, I laminated strips of holly with Texas ebony; I thought that would deliver a very dramatic formal looking stopper. You know, wedding gifts for the wine crowd (Big dream$ I know). :)

Anyway, the turning was straightforward but when I started sanding (with the lather on) the blackwood dust bled over into the holly. Even hand sanding after the fact left a dingy color. Is the holly too porous to make the lamination a viable option?

Any hints or suggestions would be helpful because the glue-up gave me a few blanks that I hate to waste.

Thanks

George

Re: Keeping Holly from looking dirty

#2

Alan Zenreich

Re: Keeping Holly from looking dirty

Alan Zenreich

perhaps try some sanding sealer, or shellac before sanding

Re: Keeping Holly from looking dirty

#3

Harry Robinette

Re: Keeping Holly from looking dirty

harry robinette

George

When I sand two contrasting woods I keep my vacuum with the brush attachment in my other hand.

Having the vac right there keeps the dust from getting into the woods pores. I've used this idea to do some pauduk and very light maple and pauduk and holly and had great results.

Re: Keeping Holly from looking dirty

#4

Re: Keeping Holly from looking dirty

John Lucas

Alan has it correct. You have to use enough sanding sealer to seal any pores in the holy. I put on one or two coats and then will apply more sanding sealer between each grit. I learned this while trying to sand a segmented bowl that had Paduak and Holly. Padauk dust will get on your couch and furniture in your house 30 feet away from here your sanding. It carries over onto holly really bad. I got online and asked for suggestions and Phil Brennion came back with the idea of sanding sealer or just plain shellac.

The problem is the dust carries over and gets in the pores. If you fill the pores, even slightly, it helps keep the dust out or makes it easier to blow out of the pores. So both suggestions above are helpful. Apply some sealer,I have also used diluted lacquer. Then blow the dust off when you change grits and apply more sealer.

this is not a good technique for production items as it's obviously time consuming.

Re: Keeping Holly from looking dirty

#5

Mike Stafford

Re: Keeping Holly from looking dirty

Mike Stafford

I have been turning birdhouse style ornaments using holly for the roofs.

I learned to make sure I used fresh clean sandpaper for these parts. If the sandpaper had any dust residues from other woods the holly would get smudged.

Of course it is easier to keep the holly pristine if you are sanding it by itself.