Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This $39 jig will make you a WOODWORKING GOD!

Super demo!

Posts

Super demo!

#1

Super demo!

Ed Moore in SW VA

Last evening the Smith Mountain Lake Woodturners hosted Mike Hunter of Hunter Tools. The purpose of the demo was to introduce carbide cutters to the group and allow them to try out the tools. It was a roaring success. Even some of the old curmudgeons made positive comments about the evening. It was known ahead of time that an opportunity to purchase these tools would occur - and folks took advantage of this.

Don Riggs assisted Mike and three projects were shown. The new Hercules tool was a big hit and it was used on a maple bowl blank. The smooth cuts and good shavings appealed to everyone. A Jimmy Clewes vase was started and a globe for a Bob Rosand style ornament was done. Opportunities to try out the tools really worked for people.

SMLW wishes Mike Hunter all the success possible and thanks him for bringing the program to us. It was a great evening.

Ed

Re: Super demo!

#2

Steven Antonucci

Water Gap Woodturners $.02

steven antonucci

We had some members take home the tools from the club library and it is safe to say that the interior surfaces on the work they brought were much improved above what they would normally have produced.

Decidedly a huge advantage to a beginner who may not have developed tool skills, as well as being useful to advanced turners for reducing the time it takes to make things and the effort required in finishing them...

Steve

Re: Super demo!

#3

Re: Super demo!

robo hippy

I find that to be the difficult part of teaching. I can get the inside (most difficult part of bowl turning) a lot smoother than newbies. How do you get them to get some thing close enough so that they can see the light at the end of the tunnel and not get discouraged by all the sanding they will have to do? Scrapers are great for smoothing out the bumps and humps. If you have it at a shear angle, and do a light pull cut, you can get a better surface than you can with a scraping cut.

robo hippy

Re: Super demo!

#4

Re: Super demo!

D Leydens

Glad to hear that Mike's demo went so well. I'll be doing a demo with Mike in a

couple of months and I'm really looking forward to it.

Way to go, Mike!

Re: Super demo!

#5

Re: Super demo!

Chuck Bjorgen

Mike is a member of our Minnesota club and was part of an August meeting in which we had four demo stations set up for various turning operations. He does a nice job showing his products and, of course, I had to go home with one of his new Hercules tools. Still learning how to use it but I think it's going to be a good one.