Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Support WoodCentral when buying things you need

I guess I can turn a sphere...

Posts

I guess I can turn a sphere...

#1

Alan Zenreich

I guess I can turn a sphere...

Alan Zenreich

As part of a club challenge due tomorrow (same one Steve A. mentioned a few weeks back), I turned a 1.25" sphere from a piece of grey stabilized buckeye burl. This is my first sphere.

I turned it yesterday, and was going to do the final piece assembly when I fussed with it a bit, finding it slightly out of round.

So, I trued it up, gave it some rough sanding, and took it into my other shop room to do finish sanding using 4 grades of abrasive on sanding mops, before going to the buffer.

Wouldn't you know it... the piece flew out of my hand, and is now somewhere in the shop. I heard it hit the floor.

I've spent the last 30 minutes on my knees, moving equipment around, and it hasn't turned up yet.

So, if nothing else, I guess I successfully turned something that bounces and rolls easily!

Lauren just said "it's in orbit"

Now I have to decide whether to spend the next hour lifiting my cabinet saw, and gutting the shop room... and likely not find it.... or just make another one.

Arrrrrgh!

Re: I guess I can turn a sphere...

#2

Re: I guess I can turn a sphere...

john lucas

Did the same thing looking for a screw for my jumbo jaws. I was changing the jaws and dropped the screw. Well dropped is not exactly what happened, more of a flip. Took me about 20 minutes to find it using a magnet and my fingers.

Re: I guess I can turn a sphere...

#3

Re: I guess I can turn a sphere...

George Guadiane

I've been in your shop...

Turn another one ;)

Re: I guess I can turn a sphere...

#4

Alan Zenreich

Re: I guess I can turn a sphere...

Alan Zenreich

Well, Lauren and I looked all over for it. I put a crowbar under one corner of the tablesaw's mobile base, and lifted it so she could look under the saw. Nothing.

Just as I was about to go turn another one, I got a flash of inspiration... and started looking 'above' the floor.

There it was, tucked very neatly in a small ledge on the back end of the rolling cabinet that the Sand-Flee/Buffer sits on. Lauren said "I would never have thought to look there".

It reaffirms one of the rules I live by: The thing you're looking for is almost always within 18" of the place you think it should be. In this case, it was 6" from the place I first looked, but hidden from view by the cabinet.

Not only can the little sucker roll, it can BOUNCE well.

So, I just spent the last hour drilling tiny tiny tiny holes into the sphere and the rest of the parts, and now I can do the final assembly.

Photos will come after tomorrow's club meeting.

Re: I guess I can turn a sphere...

#5

Steven Antonucci

It doesn't count if you don't bring it


Re: I guess I can turn a sphere...

#6

Re: I guess I can turn a sphere...

David DeCristoforo

There is a third option. Move. You always find your lost stuff when you move. Drastic I know but sometimes, that's what it takes. If not possible, I would opt for plan B... turn another.

Re: I guess I can turn a sphere...

#7

Alan Zenreich

Re: It doesn't count if you don't bring it

Alan Zenreich

Steve,

I just completed the piece and made a quick photo of it. But I won't post it on any of the woodturning forums until after the meeting.

Lauren just finished her piece too...