Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Need a tree taken down or milled?

Hunter tool

Posts

Hunter tool

#1

Hunter tool

Starry S Chan

Last week, I posted a question about using a tool very similar Hunter Tool #4. This tool is made by Harrison Specialty. It has a 5/8" round shank with a 1/2" round carbide cutter.

I tried this tool again today and my experience is better than my first trial. On the outside of the bowl, I laid and secured the tool flat on the tool rest and rubbed the tip bevel against the wood. I then rotated the tool until it started cutting and I used the handle to control the depth of cutter. This seems to work but I do not have the same confidence as with either a bowl gouge or the Easy Rougher.

When I used the same technique in the inside of the bowl, I got a bad catch. The reminded me my experience with a scraper until I grounded a negative rake on the scraper. I also had the same problem with a genuine Easy Finisher. With a bowl gouge, I am confident that I will not get a catch if I maintain bevel contact with the wood. With this Hunter Tool #4 clone or the Easy Finisher, I am never sure that I will not get a catch when I make a cut.

I remember watching a video with John Lucas finishing a bowl using the Hunter Tool #4. I cannot find this tool on the Hunter Tool web site.

Starry

Re: Hunter tool

#2

Here it is.   *LINK*

John Lucas

If the tool you are using has the 7 degree bevel like the Hunter tool then rubbing the bevel will work. The steel below the tool may have to be ground down flush with the cutter which makes a longer bevel.


http://www.youtube.com/watch?v=nfp2kvhH6Mo