Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

REAL MILK PAINT

Monster Help - Update

Posts

Monster Help - Update

#1

Monster Help - Update

Steve Criscenzo

Thanks for your suggestions everyone. They were all a great help.

There were a couple of things that made a big difference. I think part of the problem was that my angle of attack was not correct and the side of the cutter was contacting the vessel. I reground he tip to cut back the sides a bit and move the base up up so my approach angle allowed cutting with the tip of the cutter. All vibrations gone and it cuts like a dream.

A couple of other things I noticed. I was careful to stop and remove chips but because there was a belly in the form, as the vessel spun, what chips remained went to the widest part and that was where is was having problems. Lesson learned, clean chips more often. I also reduced the extension of the cutter out of the tool and that helped as well.

Finally, I was very impressed that Randy Privett contacted me directly to be sure I got it worked out. That is great customer service and most appreciated.

As with any new technique, there is a learning curve but I am very happy with the design of this tool and the results produced.

Thanks again for your suggestions.

Re: Monster Help - Update

#2

Don Leydens

Re: Monster Help - Update

Don Leydens

Glad it's all worked out. I had to do a little fine tuning for the same reasons on mine, too. I love that tool!!!

Re: Monster Help - Update

#3

Re: Monster Help - Update

Richard Jones

Steve,

Glad it worked out, sorry I told you about the articulated version instead of yours. That's what assumption gets me..........

Randy is very service oriented and has helped me out with a few issues, mostly mine!!!

Rich