Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

REAL MILK PAINT

Tool/Production gloat for Don Riggs

Posts

Tool/Production gloat for Don Riggs

#1

Tool/Production gloat for Don Riggs

Ed Moore in SW VA

About 30 days ago Don Riggs test drove a Glaser 1/2" 15v bowl gouge. Since then he acquired his own 1/2" 15v bowl gouge and the 1 1/2" Glaser scraper you see pictured below. You may be able to tell from the picture that Don put a drop-nose grind on his new scraper. Today I watched Don turn the small bowl with the MiniGlaser SRG sitting on it on the lower table using these tools and an old favorite scraper. There isn't a tool mark on that bowl and it hasn't been sanded. It looks as if it has been sanded with 220 or so. The remaining pieces you see have been turned by Don in the last 30 days or so using these tools. He uses his new scraper for the finish cuts and he gets a remarkably smooth surface. Some of these pieces had been turned years ago and Don took the dried bowls and re-turned them to their final form. It took Don 20 - 30 minutes to turn the bowl today and he was not hurrying. Not bad for a retired Navy pilot who turns part-time!


Ed

Re: Tool/Production gloat for Don Riggs

#2

Bigger picture

Ed Moore in SW VA


Hopefully this picture will show better detail.

Ed