Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Find a woodworking club near you

Air filters for vacuum chuck set-ups

Posts

Air filters for vacuum chuck set-ups

#1

Air filters for vacuum chuck set-ups

Randy Johnson

After thinking and dreaming about it for a long time I�ve finally decided to set up a vacuum chucking system.

The main components should arrive sometime in the next few days from Packard Woodworks. I plan to manufacture the actual chucks using information and ideas gathered from many hours of net surfing and several magazine articles.

I had planned to build the air filter between the bleeder valve and the pump using pipe and the floss used in aquarium filters. Somewhere along the line I ran across the suggestion that a filter be installed on the bleeder valve as well. Inline automobile fuel filters were suggested and this seems like a good (read cheap) solution. Is anybody using fuel filters in their vacuum systems, and if so what make and part number? One that I�ve looked at will filter anything over ten microns. That isn�t small enough to keep out Giardia cysts, but I doubt the pump would care. Is it small enough to keep out dust that WOULD damage the pump over time?

Re: Air filters for vacuum chuck set-ups

#2

Re: Air filters for vacuum chuck set-ups

Ken

That's what I have on my bleeder line. I take it off and clean it periodically, no problems in 5 years. The last vacuum chuck that I made is just a flat plate, about 6" in dia. with a piece of self stick art foam on it with concentric circles drawn to help center pieces.

Re: Air filters for vacuum chuck set-ups

#3

Dennis in Southern Oregon

Re: Air filters for vacuum chuck set-ups *LINK*

Dennis in Southern Oregon

Randy, I set up a vacuum system recently and found an article by Charles B. Ford very useful in finding the needed parts, building the system, and selecting or building the chucks. If you have a suitable filter at the inlet of the pump, you do not need a separate filter on the bleed valve input other than perhaps a strainer to prevent debris from getting sucked in.


http://www.carlford.info/pages/demos_classes/vaccum_chucks_demo/Vacuum_Chucks_Demo.pdf

Re: Air filters for vacuum chuck set-ups

#4

Re: Air filters for vacuum chuck set-ups

Doug Wolf

I've used a fuel filter from Wal-Mart, I think they were fram, on a couple of systems just before the vacuum pump. They are clear plastic with a tubing connection on each end. Just put them in your tygon tubing with hose clamps. You can see through them to see if they are contaminated. One guy sucked sawdust out of his headstock when he turned on the vacuum pump and it showed up real good (he forgot to blow air through the headstock before he hooked up the vacuum line).

For the air bleed, I just slipped a small sock over the tubing and put a rubber band around it to hold it on the tubing. You just need to keep out the big shavings. The air filter by the pump will get the dust.