Flying curls!!!
Mike Stafford
This weekend I had a chance to try out a Glaser 7/16" detail gouge on some very old, very dry and very hard persimmon. This wood was, at one time, used for wood golf club heads. Its reputation for hardness is well earned.
I sharpened the Glaser detail gouge to my preferred bevel and put tool steel to wood steel (in a manner of speaking
).
The result is pictured below. The strips of end grain curls flying through the air were so impressive I had my wife take a picture. She has always been my brave photographer and has taken all the pictures for my tutorials and articles.
I have to say the tool lived up to all the hype. It cut cleanly and as I pared away the waste wood on my jam fit lid blank there was seemingly no resistance. Sometimes when a lid is jam fit on the body and the tool is not cutting as cleanly there is a tendency for the lid to turn on the body tenon. Not in this case. I removed almost 1/2" of hard persimmon without any problems. Not bad for a first try with this tool Ed Moore suggested that I try. I enjoyed the size and heft of the handle and found it comfortable in my hand. A very nice tool that performs well!
After finishing the shape of the lid I chucked up a piece of hard maple for a go at hollowing end grain. Again the performance was very good. I was able to hollow into the end grain to more than 2 inches very easily taking full cuts. After that I had to lighten up on my cut as the overhang over the tool rest began to take effect and I experienced a little chatter. After reducing the depth of cut I went as deep as I usually do which seldom exceeds 2 1/2" - 2 3/4". Much beyond that and it is time for something other than a gouge.





