Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This $39 jig will make you a WOODWORKING GOD!

Latest Low Relief 3D Laser "Carved" Piece

Posts

Latest Low Relief 3D Laser "Carved" Piece

#1

Latest Low Relief 3D Laser "Carved" Piece

charlie belden

Have FINALLY gotten back to playing with doing low relief 3D laser "carving" from Gray Scale images.

Here's the gray scale image that was imported into CorelDraw X3 and "printed" to an Epilog laser

"printer"

[

Here is a photo of the piece after laser "carving" (Left) and after it was then sandblasted with an airbrush "air eraser" shooting 220 grit aluminum oxide to remove the charring from the laser. I think that some more work on the gray scale image, some more experimenting with the speed and power of the laser and multiple "light passes", along with a finer grit blasting material - and some subtle low relief "carving" might be attainable.

What I'm after is to have the "carving" so subtle that it would only be noticable when lit almost from the side or almost directly above - to cast shadows. Am working on some web pages on how to import images into CorelDraw, set the Corel's center to the center of the imported image, how to set up the laser so the pattern will be centered on where you want the center to be on your piece and setting for the laser's "printer driver". Will post the url when that's done.

Questions, suggestions, comments welcomed.


Re: Latest Low Relief 3D Laser "Carved" Piece

#2

Re: Latest Low Relief 3D Laser "Carved" Piece

Ralph E Watts

Charlie,

I think your gonna have to quit this fooling around with laser carving... your going to put us carvers out of business.... :) BTW cool looking vase. nice work... Best regards, Ralph

Re: Latest Low Relief 3D Laser "Carved" Piece

#3

Re: Latest Low Relief 3D Laser "Carved" Piece

charlie belden

Laser low relief "carving" maxes out at about 1/16" deep. And the width and height on curved surfaces are limited, the beam spreading and blurring beyond its focal point. Don't think any carvers have to worry about laser engravers replacing them - any time soon ; )

Still need to see how it does on a larger background field to have the "carved" image stand proud of the background rather than down into the surface of the piece.

Almost have the illustrated instructions for the basics of the process done. Still have much to learn - and document.

Re: Latest Low Relief 3D Laser "Carved" Piece

#4

Re: Latest Low Relief 3D Laser "Carved" Piece

Keith Newton

Charlie Belden, I want to send you a couple of photos to see if you think they will work for your laser.

Could you drop me an email? My computer is in the hospital, and I don't have your address in my phone.

I have a galery show coming up, and am looking for some clean simple shapes with just a little detail.