Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

Anchorseal on old surfaces

Posts

Anchorseal on old surfaces

#1

Anchorseal on old surfaces

Paul Simon

Four of us from the Montgomery Co wood turners Chapter went out tonight to salvage some black cherry wood. We got some crotches, 10 inch limbs, and some sections of 2 foot wide chunks. Nice haul, and the owner was delighted to have us take it.

They had been down for 2 to 4 + months. Can anchorseal be applied to the weather-aged surface, or should the pieces be trimmed for a newcut surface.

Should the half cylinder pieces be cut into rough blanks prior to using anchorseal, or could they be cut up a month later (after sealing).

Re: Anchorseal on old surfaces

#2

Richard Allen

Re: Anchorseal on old surfaces

Richard Allen

Phil Brown has more experience with green wood than anyone I know. All the wood I have seen at Phil's place are cut into slabs. This may be because slabbed wood is easier to stack and sticker.

Unfortunately Phil is off to the symposium so that resource you have is unavailable until he returns. Make sure you talk with Phil about it at the next meeting.

I would cut out the pith, cut off any checking, coat with the green wood sealer and store it so the sun can't shine on it.

Re: Anchorseal on old surfaces

#3

Richard is right on target with.......

JamieDonaldson

..his suggestions of cutting off end grain checks down to good wood, then sealing. Cherry is prone to checking sometimes before the tree hits the ground, and slabbing out the pith will also be beneficial.

Re: Anchorseal on old surfaces

#4

Steven Antonucci

What I would do (different than most)

steven antonucci

Assuming that the wood is already checked, I would leave it alone. If the checking is deep, odds are that it is deep enough to prevent further spreading. Cutting it and exposing a lot of surface area to evaporation will likely encourage more checking.

I might even go as far as slapping Anchorseal over the checked surface, and only cut them back to fresh when I was ready to use it. I lose a little bit of wood, but then again, I collect an awful lot of it, so I really don't care.

Steve

Re: Anchorseal on old surfaces

#5

Re: What I would do (different than most)

john lucas

I'd do like Steve suggested. You will have to cut that area off later of course but that wood will itself will help slow down the drying of the rest so hopefully the checks won't progress any further.

If I really want to save it for a moderate time I cut bowl blanks and seal them totally with parafin wax. It's not permanent and does take some time to do but it's worked great for me. I use an old electric skillet to melt the wax. I hot glue the temperature dial to the lowest setting that will melt the wax. That's about 140 degrees and way below the flash point of wax so it's safe. However I always keep the metal lid handy on the very slim chance there could be a fire.