Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

ADVERTISE HERE - FREE TRIAL

I know there's a lot of make your tool makers...

Posts

I know there's a lot of make your tool makers...

#1

I know there's a lot of make your tool makers...

Randy Gleckler

Any one tried to make your own spiraling tool yet? Got to try one this past weekend and it seemed like something fun to mess with. Checking the cost to buy one and it quickly put it out of range. Figured someone had to at least have tried.

Re: I know there's a lot of make your tool makers...

#2

Steven Antonucci

By spiraling, you mean knurling?

steven antonucci

I haven't actually tried it yet, but I assume you are talking about one of the Decorating Elf style tools? If so, a knurling wheel can be had for very little cost, and the bar it attaches to can be filed or ground flat pretty easily. heck, it you made one of them carbide holding tools, that would suffice to hold a knurling wheel.

I'm guessing $3?

S

Re: I know there's a lot of make your tool makers...

#3

Re: I know there's a lot of make your tool makers.

john lucas

Randy I haven't made one yet but if you'll let me a little planning you can come over and we'll build one. I need to find a gear or other device to act as the "knurling" cutter. The rest is easy. The Gear Sorby uses looks like a bicycle idler which should be easy to come up with.

You can also buy knurling cutter replacement wheels that will resemble the

Sorby mini texturing tool. Or we could just make our own which would produce a pattern that's different than either.

Any way, give me a week or so get back with me.

Re: I know there's a lot of make your tool makers...

#4

Re: I know there's a lot of make your tool makers. *LINK*

Don Orr

From the WC Articles section.


http://www.woodcentral.com/cgi-bin/readarticle.pl?dir=turning&file=articles_819.shtml

Re: I know there's a lot of make your tool makers...

#5

Leo Cuellar

Re: I know there's a lot of make your tool makers.

Leo Cuellar

Hey John, something else that might work are the spike wheels from the old style of stone dressing tool. They are pretty cheap & come in at least 3 sizes.

Re: I know there's a lot of make your tool makers...

#6

Re: I know there's a lot of make your tool makers.

John Lucas

They might work. I think they are quite different than what Sorby sells but I have one and can dissassemble it and try it in my Sorby handle to see.

Re: I know there's a lot of make your tool makers...

#7

Mike Peace

Re: I know there's a lot of make your tool makers.

Mike Peace

I have a Sorby spiraling and texturing system and love it. I recently made a separate handle for the texturing wheel from a 5/8" shaft from an old treadmill. This keeps me from having to swap wheels. The rod was already drilled so I just cut a little off and made a handle. The texturing wheel does not have to have a slot or flat area cut to work well. I do believe the spiraling wheel would need a slot, though. I notice that Hartville Tools has Crown replacement wheels for their spiraling/texturing tool that are a little cheaper than the Sorby ones.