Nova DVR-XP lathe
Jesper, Denmark
During a local turner's meet in Copenhagen, the shop owner demonstrated his new Teknatool Nova lathe. This seem to be a nice unit, but with a strange flaw:
The computer controlled motor seems to have a very controlled ramp-up in speed and settings for safety stop in three stages and an active speed control, which balances the power input to the amount of force generated by the tool. So far so good.
When switched off, the spindle takes ages to coast down. There seems to be no controlled slowing down, as I am used to with the VFD controlled three phase motor on my General.
The instruction manual does not talk about slowing down or any adjustments available though the input.
Is this normal?....and how do owners of this lathe feel about it?
Are there any way to get this braking action? The manual sems to indicate that there are some hidden adjustents available by pressing two input pads at the same time, but gives noo further information.
Incidentally, although sold here in Denmark, the lathe does not meet EU regulations on two points: The fist is that there is no local language manual - which is a must to be legally sold, and there is no provision for stopping in <10 seconds as required.



