Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Find a woodworking club near you

Chinese Balls *LINK*

Posts

Chinese Balls *LINK*

#1

Chinese Balls *LINK*

John Lucas

I don't know why they don't know what these things are. It's obvious that a turner was involved. It may be stone or pottery but I'm sure Fred Holder's ancestors did these.


http://www.foxnews.com/scitech/2011/06/10/dodecahedrons-purpose-remains-mystery/?test=faces

Re: Chinese Balls *LINK*

#2

Steven Antonucci

Not so fast on the lathe

steven antonucci

I agree that they look like chinese balls, but the article mentions that they are usually bronze and Roman. I am not sure that the ancient Romans had all that much "lathe" work and I wonder if the originals were turned in wax and then cast?

I think the bigger question the pose is "what the heck did they do with them?"

Someday, I am going to try to make one...

Someday.

S

Re: Chinese Balls *LINK*

#3

Katherine Kowalski

Re: Roman Balls

Katherine Kowalski

Obvious? Both inside and outside faces appear to be flat. I don't see any turning in this piece. (Unless one is thinking of hollowing?) Probably was cast (bronze), or carved (stone). There is no mention of any nesting characteristics either. (Perhaps you should re-term them to be "Roman Balls"?)

Interesting piece nonetheless.

Speaking of Chinese balls... at an art exhibition in Singapore, I once saw a 10" sphere of jade that was made into a "chinese ball" -- with many many layers inside. Remarkable craftsmanship. There was a carved ship there too -- about 9 ft. long and 6 ft. high, the entire piece carved from green jade, with yards of decorative chain, painstakingly worked.

Katherine

Re: Chinese Balls *LINK*

#4

Re: Chinese Balls

Fred

I have no idea of what they are or how they were used. They appear to be cast, probably brass or bronze. The hole configuration is that of the Chinese Ball with 12 equally spaced primary holes. The knobs appear to be located on the 20 auxilliary positions (the center point of each of any three primary holes, which form an equalaterial triangle). I doubt that there were other balls inside as is the case with the Chinese Ball.

I saw an Ivory Chinese Ball with 13 balls, with each ball intricately carved. I often wonder how the Chinese made these balls without lathes and the modern tools. At this point, I've only been able to make Chinese Balls with up to seven levels using the tools that Christian Delhon of France was demonstrating and selling a couple of years ago. I purchased a set of his tools, which will make a seven ball Chinese Ball. Unfortunately, Christian has decided to quit making them.

If you belong to the AAW read my article in the June 2011 issue of American Woodturner. It tells how to make the five level Chinese Ball using the Crown Tools.

Re: Chinese Balls *LINK*

#5

Looks like a slingshot weapon to me.

Jack Savona