Trying to help my club setup some video equipment for our monthly Club demo's. Figured with the wealth of knowledge out here there might be some people with advice/opinions of things I had not considered with my limited experience in doing this. Thank you.
I know that some folks prefer not to be video recorded at club events. Make sure you have their permission.
As far as what we do, we usually use the camera to "enlarge" the presentation. I suspect that we have DVD's in the library, but I don't know that I've ever seen one go out. The camera is just used so that we don't have to crowd the lathe. Having a basic understanding of how to record and balance for lighting would be a start, since our videos are always completely blown out and over exposed...
Half of the responsibility for a successful video lies with the person behind the camera and the other half lies with the demonstrator. The video image needs to be placed so that both the camera operator and the demonstrator can see it too. When the demonstrator is trying to show something specific such as a tool presentation, tool grind etc, he/she needs to look at the image and assure that the the specific information is being properly captured in the video.
Over head cameras with remote adjustment save lots of in process camera adjustments but any overhead views are better than none at all. Down the line views from the tail stock side are a minimum.
And now the most important thing for video operators. The operator is there to benefit the audience and must work in synch with the demonstrator. Too many camera operators just want to be up close and personal with the demonstrator and the demonstration soooo.....I say again, you are there for the benefit of the audience.
Randy, if you're looking for equipment recommendations there are others with that experience to help you. However the best equipment will not compensate for poor camera operations.
Randy I have not looked at cameras lately but have been doing a lot of Demo's at places that use them. I like at least 2 cameras. One above that can show how the cuts are done and see the shape of the piece as it emerges. The other camera should have really good zoom capability and be on a tripod but should be moveable by the operator. This second camera is the detail camera. It needs to be positioned so that they can actually see the cut and how the tool is being used. You will have to move this camera constantly, especially if the demonstrator (me included) gets involved with the crowd and forgets that he's blocking the view. In that case it helps if the operator can move and maybe even ask the instructor do demonstrate that cut again so the crowd can see it. All of them I've ever taped have been more than willing to oblige.
The club in Dalton GA has remote camera positioning devices. They aren't very expensive and allow the main camera operator to remotely adjust the position. I believe he said these were part of an X10 video survailance system that you can buy online or even Radio Shack. It is really nice for fine tuning the top camera. You can position the camera closer for a larger view because it's easy to move the camera.
some places use a 3rd camera positioned out near the tailstock on the far side of the lathe to view hollowing of bowls. It sort of augments the hand held camera and may be quicker switch to this camera instead of moving the tripoded camera.
Our club is in the process of revamping our video and sound system.
The sound part for our existing system is from a mic from the front camera
so it�s almost nonexistent and will be a new system by itself.
I need a visual so I�ve made a line drawing on a white board showing the lathe, some fixed cameras, main camera on a tripod, monitors, switcher and a recorder, after that its research to decide what to put, and how much to spend, in each box.
As far as product and model number for each box, that�s the spend part. I had no
idea those little mics coast so much. If you want, as we fill in the boxes, I can send an
update. Not sure what your timeline is but I think we want ours operational by October
or there abouts.
c
As far as how to video, that�s another thread in itself�
...Best Practices/Demonstrations is a tutorial that I wrote several years ago, and most of the info is still useful. It helps explain camera operations for demos, and the way in which the equipment can best be positioned.