Tools of a traveling "pro"
steven antonucci
I occasionally demonstrate and I teach once annually(and get paid), so that makes me a traveling pro I suppose. When I pack my tool roll, I typically will take a subset of my tools with me based upon what I am demonstrating. I figured it might make sense to plow through some of the clutter about what and why, and open the kimono about allegiances.
Here is my tool roll, what I paid, and how I acquired them (L to R):

1- 3/4" Sorby Scraper bought on eBay with about 8 other Sorby tools for $72 from a guy in Australia, who flew them to the US before mailing them to me from Houston. Unhandled, so I made it different so I could find it
2- An Ellsworth Style hollower that I made for about $3
3- A Doug Thompson detail gouge that was a factory reject. Bought it from Doug at Five Barns with a 3/4" skew for $20 for the pair. Best $10 I ever spent, and it pissed Doug off that I told two guys that I got it for $10 (and they told 2 more, and so on...)
4- A Oneway 1/2 Bowl Gouge that I bought at a woodworking show. Until then, I used a 5/8" Sorby that came with #1. Paid $55, unhandled.
5- 1" Sorby Skew, also came with #1. As you can see, that eBay buy was an all-time gloat
6- 5/16" Sorby spindle gouge...that's right, also from #1...
7- 1" Sorby SRG... yessir also a #1
8- A Sear diamond parting tool from my original set of tools. Works fabulously
9- A homemade hook tool in the Sears parting tools handle. Cost $1 to make.
I never leave home without most of these, although if I am going somewhere with tools in the shop, I leave the SRG, spindle gouge and the parting tool behind because they are commodities. If I am not hollowing, the Ellsworth bar stays home.
The rest are always in my roll if I am going somewhere. Here is why.
In a pinch, I can use the wings of the bowl gouge to rough a cylinder. I can cut a bowl cleanly, but I know that not everyone can, so I bring a scraper along to show how to use one properly. The hook tool is unrivaled for cutting end grain cleanly. I always try to show a finished surface of a skew (cut vs. sanded). And the detail gouge gives me a lot of options as a spindle tool for rolling beads, cutting tenons, getting into tight places and so forth.
Lastly, I try to bring things like the hook and the Ellsworth tool to educate people that the stuff in the catalogs can be made equally as well as the "commercial" stuff with almost no effort. Here is a picture of from my toolmaking workshop that I held last month in my shop. As you can see, people from all walks of life are in attendance, and we made about 60 tools that day.
I used one at the club meeting last night, and it left a flawless surface on dry poplar. Now the other club want's to do the same workshop...
I got lucky, but my entire roll is slightly more than $100...
Steven



