Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Portable Sawmill & Tree Service – Abingdon, VA

Salt Mill question

Posts

Salt Mill question

#1

Salt Mill question

Ricc havens

due to the corrosiveness of salt should the inside of a salt mill be sealed or finished in anyway? if so, what do you recommend?

Thanks

Ricc Havens

Re: Salt Mill question

#2

JL

Re: Salt Mill question

JL

Salt mill or salt shaker?

Yes, salt is corrosive. Salt is also somewhat abrasive. I'd rather be eating wood than finish.

To answer your question - wood is relatively inert (so are most finishes). I usually just leave the wood as is. I do make sure that it is sanded as fine as I can manage though. I usually do my shakers to 220 grit or so. I have taken a couple to 320.

Re: Salt Mill question

#3

Forget any inside finishing, because .....

JamieDonaldson

...the wood won't rust! :D

Re: Salt Mill question

#4

Walt Bennett

Re: Salt Mill question

Walt Bennett

Wood won't rust, but any metal will corrode from salt exposure - including stainless steel. I'm hoping your using one of those composite grinders.

Re: Salt Mill question

#5

Re: Salt Mill question

Ricc havens

Walt, yes I am using the mills specifically marketed for use in salt mills. I just wasn't sure if the corrosiveness of salt would have any reaction with maple or walnut therefore requiring some sort of sealing inside the mill

Thanks

Ricc