Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

Wolverine Mini Platform

Posts

Wolverine Mini Platform

#1

Dennis in Southern Oregon

Wolverine Mini Platform

Dennis in Southern Oregon

To quote Bill Jones, "Like me, some of my tools are getting perilously close to the tang". I like to use the Oneway Wolverine platform to sharpen skews, scrapers and spindle roughing gouges, but I am finding that the standard platform is too wide for some of my more experienced tools. I was considering performing major surgery to the platform to reduce its width when I spied the Mini Platform in a catalog that I received last week. I ordered it and just received it today. It is just what I was looking for. It gives my tools another inch or more of life and is a drop-in replacement for the standard platform.

I have no association with Oneway except that I own a lot of their equipment.

Dennis

Re: Wolverine Mini Platform

#2

Joe Fleming

Re: Wolverine Mini Platform

Joe Fleming

I just bought one too - same reasons. Joe Fleming - San Diego

Re: Wolverine Mini Platform

#3

Katherine Kowalski

Re: Wolverine Mini Platform

Katherine Kowalski

All of my platforms have been altered so that a slot is cut in the wheel edge, and their corners are rounded, allowing much shorter tools to be sharpened. (At least until they get any shorter!)

Haven't seen this mini platform, but I think it definitely needs to be headed my way... Which catalog did you see it in?

Thanks,

Katherine

Re: Wolverine Mini Platform

#4

Dennis in Southern Oregon

Re: Wolverine Mini Platform

Dennis in Southern Oregon

I ordered mine from Craft Supplies. I was surprised at the low cost--$29.99 for the whole assembly.

Dennis

Re: Wolverine Mini Platform

#5

Re: Wolverine Mini Platform

John Leonard

I also got mine today for the same reason :) . John L.

Re: Wolverine Mini Platform

#6

JL

Thanks for sharing

JL

Re: Wolverine Mini Platform

#7

Spence

Re: Wolverine Mini Platform

Spence

Have had mine for a few months now and use it most of the time. IMHO I think its better for most things than the original which I had also altered by cutting a slot in the front so it could go around the corners of the wheel. With the smaller one there is less drag and better control of the tool being sharpened.