Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Find a woodworking club near you

Serving Platter

Posts

Serving Platter

#1

Serving Platter

ronnyeelen

An interior designer lady, who also designs glassware, asked me to make a serving platter. According to her own design.


Made of American Wallnut, it measures 15" wide, 1.5" high.

This is the second prototype.

It can be used on both sides. Which of course means that both sides needed to be equally flat and well finished :\ Each side has a different design of the rim. I didn't take a picture of the other side, forgot that.

Last weekend she came to the house to take a look. And she also brought along her glasses she designed. Nice!

She liked what she saw. I was kind of happy with that :) When she is finished with all her glasses she will start commercializing them, together with the serving platter(s). It still depends on what her partner thinks of it though. So, keep fingers crossed.

Even though she liked it, all kinds of comment are still welcome :D

regards

Ronny

Re: Serving Platter

#2

Re: Serving Platter

Jorge Casta�eda

Ronny,

A double sided platter is a novel idea for me and I like it!

Good work.

Re: Serving Platter

#3

Re: Serving Platter

Carol Reed, Strawberry, AZ

Nice, Ronny. I really like it.

And nice marketing touch. Collaborate with the designers. I like that, too.

Re: Serving Platter

#4

Re: Serving Platter

Bob Macgregor

That is pretty slick, but, when it is in the configuration shown in your picture, how do you pick it up from the table?

BOB

Re: Serving Platter

#5

Re: Serving Platter

ronnyeelen

thanks for the kind words.

Bob, the picture doesn't show. But the bottom side also has a rim, like the top side, but it is further from the edge. So the outer edge, when laying flat, does not sit flat on the table. There is still room for the fingers to pick it up.

The design allows for about 2 digits (of the fingers) to be put under the outer edge.

In fact, there is still one change I already know off to be made, and that is that the rim on the bottom side needs to be 5mm higher, to create more room for the fingers.

Ronny

Re: Serving Platter

#6

Ken Vaughan

Very nice

Ken Vaughan

The centering of the flat grain in the center provides a nice sense of balance to the piece. Well thought out design that does not rely on fancy wood grain. Provides a message of balance and stability to me.

Appreciate your sharing the idea and approach --