Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Have a question? Ask Woody!

My first largish platter...

Posts

My first largish platter...

#1

Leo Cuellar

My first largish platter...

Leo Cuellar

for your critique. 15 & 1/2" Maple with 2 coats shellac & 2 of semi-gloss lacquer. The rim was my first real trial of the Modern Masters metallic paint. I wish I had taken a photo of the rust effect before I applied the finish, as I was trying to emulate one of Terry Scott's works. It looked absolutely believable, but the shellac muddied it up & killed all the red & orange color.





The rim treatment was a real departure from what I would normally do, but some things that Charlie Belden posted a while back made me decide to play with fire as a tool. The grooves were "carved" with a steel cutting abrasive disk in a 4" angle grinder. They were then "softened" with a propane torch & brushed with a brass "toothbrush".



I cheated on the painting by leaving a small bead inside the rim detail to attach masking tape to. After everything was dry I finished turning the face. A little bit scary as I'd never tried anything that tricky before & was sure I'd cut too far out into the rim. :b I turned this a few months ago, but the weather only just warmed up enough to try spraying a few days ago.

Re: My first largish platter...

#2

Great Job !

Don Orr

Re: My first largish platter...

#3

Dale Jablonski

Re: My first largish platter...

Dale Jablonski

beautiful!

Re: My first largish platter...

#4

Leo Cuellar

Re: My first largish platter...

Leo Cuellar

Thanks guys! I just got lucky that it didn't warp out of shape, as I did the rim detailing right after turning it.