Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This is the most versatile work station you will ever use

My Safety Routine...

Posts

My Safety Routine...

#1

My Safety Routine...

Wally Dickerman in Arizona

I have a very strict routine with safety in mind before I start turning when I mount a piece on the lathe.

I do a lot of my turning on the outboard side of my Oneway with the lathe in reverse, (I'm a lefty) so I always check to see that the chuck or faceplate is locked on to the spindle.

I make sure that the blank is securely fastened to the lathe.

I check to see that the speed setting is where it should be. I hate nasty surprises.

I check to see if the lathe is in forward or reverse. I had a visitor in my shop a few days ago and I carelessly neglected to observe this, and even worse, the locked on rule. I flipped the switch and in an instant the piece was wobbling. Luckily, the tool rest kept the piece from flying into orbit before I could hit the stop button. A close call and very embarassing. Sometimes conversations get in the way of doing things right.

I give the piece a spin to make sure that it clears everything.

I stand back out of the line of fire before hitting the on button.

Sometimes accidents are caused by something stupid we do. Several years ago when my lathe was brand new, I was working to get it leveled. With the lathe running and vibrating and a fairly large piece mounted between centers, I was down on my hands and knees adjusting the leveling. I reached up to turn the speed knob to slow the lathe down....yep, I turned it the wrong way, the speed went up and the piece came flying off the lathe and bounded around the shop. Missed me by inches. It made a very loud bang as it hit something. Scared the heck out me. That was enough for that night. I turned out the lights and went into the house.

Re: My Safety Routine...

#2

Re: My Safety Routine...

Barry Irby

Wally, One evening I was ripping a board and wanted the saw to stop so I could reset the fence. I reached out with my left hand with the intend of pinching the blade between my thumb and forefinger to stop it. Somehow the realization of what I was about to do registered and I was dumbfounded. I left the shop immediately, knowing full well I was not qualified to be there that night.

Re: My Safety Routine...

#3

Re: My Safety Routine...

Craig Daymon

I'd like to add another check to your list Wally. This is one I have been guilty of probably more often than not.

Make sure the work area around the lathe is clear/cleaned (clean being a somewhat relative term). If something does go wrong and you have to make a quick move, you don't want to be tripping on scraps of wood or mislaid tools. Basically, make sure the exits are clear.

Re: My Safety Routine...

#4

Keith Tompkins

Re: My Safety Routine...

keith tompkins

Something stupid I almost did....I sucked up a rag into my dust collector. It was making a huge racket, so I shut the thing off, then waited for it to stop. I couldn't hear any more noise, so I pulled the hose off and was going to put my hand into the impeller to remove the rag remnants. Just before I did, I grabbed a stick and poked it in, just in case. BANG! The stick snapped off! O Man! I would have lost a few fingers. I cleaned and restarted the system....bad vibration. I had bent one of the impeller wings.