I worked a very long week this last week and took the morning off to go to Nashville to the craft fair. When I got back I thought I would turn a piece of the Bradford Pear I have. Well it was getting quite thin and I usually will stabilize the outside with my finger. I was shear scraping which I've done a hundred times and bowl decided it didn't want to get any thinner. No matter how fast you think your reflexes are they aren't fast enough for this. Cut the end of my finger. It's sore but not cut very deep. I won't turn the next one this thin.
Years ago my son was turning a very thin bowl. I walked through the shop and heard the wood screaming. I questioned him to be careful that it was getting too thin and walked out. The bowl blew up about two seconds later. what I found interesting was his reaction. When it happened to me I have to grieve for the lost bowl and the effort. (Oh man! I was so close and that was such a nice piece of wood.) I may have to go do something else for a while. His reaction was, "I need another piece of wood."
Odd you should mention this. This happened to me yesterday. I haven't done this in a long time but seeing it happened to you makes me feel a little better. The good thing is I wasn't hurt, just my pride!!
I had a vase explode a few days ago. I didn't take any photos, which is too bad, as we would have 3 Powermatic lathes attached to dashed hopes...
This is especially interesting in light of the recent buzz about another lathe-induced injury, and all manner of safety practices. I was given a pretty chunk of Red Cedar with beautiful deep reds and white sapwood, but unfortunately, it had been sitting too long, and had developed surface checks all along the sapwood. I glued them with thin CA, and was surprised that some were more extensive than I thought -- I'd never turned Red Cedar before, and the invisible cracks weren't what I was used to. I turned a natural-edge vase on the pith with sapwood all around the rim, and quite a number of CA-filled hairline cracks around the edge.
I'd have been fine, but the wood was soooo pretty I decided to try coring the inside of the vase, and got a little too confident with the coring rig. I heard the sound change, and somehow knew that I should stop and try breaking the core out, but I didn't. The core was only supported by about 1/2" of wood, which flexed and split in two (another unseen crack?), and the vase was blown to bits. I did have a face shield on, was not standing in the firing line, and I wasn't hurt at all.
So, I made a number of mistakes, like turning cracked wood, not stopping, and taking chances with a new species for me. If I intend to keep my fingers and eyes, I'd better listen to that voice of wisdom next time!