Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

Thoughts on church torches?

Posts

Thoughts on church torches?

#1

JL

Thoughts on church torches?

JL

I got my bed extension for my 1642. I'm ready to start work on the church processional torches.

I figured I ask opinions on my ideas.

They will be using oil filled candles with a threaded base (1/2 x 13 tpi). I was figuring on making the poles about 45" or so long. There will be a small "saucer" on top of the pole with a "candle cup" that is purely decorative. I was going to drill out the top of the torch for either a piece of all thread or a portion of a 1/2" bolt.

So I got to thinking. I was figuring on making the pole diameter about 1 1/4". I figured that would be substantial enough to give the acolytes (torch bearers) something to grab. I was thinking about making a tenon on the pole end on which I could mount the "saucer" or "bowl". The tenon would extend through the saucer and I was going to mount the candle cup on the end of the tenon.

The candle cup would have a 1/2" through hole and a partial hole for the tenon. I was thinking about making it so I could just put a bolt through the hole (for the candle). I would then epoxy the bolt in the candle cup and glue the entire thing to the top of the pole. I would probably recess the hole in the candle cup so that the bolt head wouldn't interfere with the gluing of the tenon.

Comments? Other thoughts? Do ya'll think this would work?

TIA

Re: Thoughts on church torches?

#2

Walt Bennett

Re: Thoughts on church torches?

Walt Bennett

Everything you've planned sounds good, but I'd add a little 'human' considerations. How old are the acolytes that will be carrying them as an example? You might add texture to where they'll be holding the poles, and be certain to make gripping areas thin enough for younger hands (maybe 12 or so?).

Re: Thoughts on church torches?

#3

Re: Thoughts on church torches?

Carol Reed, Strawberry, AZ

If I remember correctly, the 'saucer' is called a 'bobier.' When I made these, I drilled a hole for a brass threaded insert. I used a short piece of all-thread rod threaded into the brass insert. The bobier went over the all-thread and the candle was screwed unto the all-thread holding the bobier in place. Kerry Candle has bushings available to change thread diameters if needed.