Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A natural, durable finish with minimal coats and fuss popular among woodworkers, flooring professionals, and furniture makers

Hophornbeam for Bill Tindall

Posts

Hophornbeam for Bill Tindall

#1

Hophornbeam for Bill Tindall

Mike Foster

Here are a few photos from Eastern Hophornbeam that grows on our property in Vermont. Doesn't quite have the same look as the photo you posted Bill. The article you cited showed a tree that looked more similar to what I find here. Not saying that it isn't hophornbeam, just that it doesn't have quite the same look. The first two photos are really more typical of the hophornbeam around here but it can look shaggy like the third photo. I'm no expert, but the bark of the tree you posted just looks a bit different to me.

Mike




Re: Hophornbeam for Bill Tindall

#2

Re: Hophornbeam for Bill Tindall

robo hippy

Quit it, you are making me drool!!! Never turned any of that.

robo hippy

Re: Hophornbeam for Bill Tindall

#3

Very hard

Jorge Casta�eda

They used to make the beam for the prairie schooners and spokes for the wheels.

The spanish name for it is "quebracho" meaning ax-braker, so it is one of the several so called ironwoods. Turns well.

Re: Hophornbeam for Bill Tindall

#4

Re: Hophornbeam for Bill Tindall

George Van Beynen

Hey Mike, what size are those? They look larger than ours, around here a 12" diameter is a big one.

Re: Hophornbeam for Bill Tindall

#5

George, Here is a link that you may like *LINK*

Keith Newton----Little Rock, Arkansas

I like to visit huge trees up close, so whenever I travel, like to see if I pass near anything on this list.

Beware: Any of you turners that have never gone down this list, clicking on the little camera image over on the right column. Before you start, get a large glass of water to stay hydrated, and another to catch the drool. There is some major turning eye-candy here.


http://www.americanforests.org/resources/bigtrees./register.php?details=4518

Re: Hophornbeam for Bill Tindall

#6

Re: Hophornbeam for Bill Tindall

Mike Foster

These are on the large end for the hornbeam around here. Probably 14-18" in diameter. More typical of the trees around here would be 6-12". I have one even larger standing hophornbeam that probably approaches 24" but it has been dying for the last couple years, and I think is not going to bud out at all this year. Unfortunately it is in a place that is hard to get to with my little tractor. I have a 32 hp Kubota with a winch for logging, but it is no match for the forwarder that was used to selectively log our woods about 3 years ago. It will have to wait till winter in any case as it is mud season and just too wet in the woods. I would tear up the ground with the tractor (I have ag tires) getting to it and getting it out. I can't tell, but it is likely to have a rotten hollow core. There is a live cherry tree (probably about 14-16") that fell last winter near it, and is leaning on some other trees. I'll probably try to get both once the ground freezes.

Re: Hophornbeam for Bill Tindall

#7

Re: Hophornbeam for Bill Tindall

George Van Beynen

Those are some impressive size trees. I have a 1150 4WD John Deere with a Farmi winch for the same purpose as you. Winter is a must for skidding and keeping clean. Our woods are saturated this year, can't even go down the main trail or the ruts will be there forever.