Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

How best to saw ambrosia maple logs

Posts

How best to saw ambrosia maple logs

#1

How best to saw ambrosia maple logs

Charlie Anderson

My neighbor took down some trees and one is ambrosia maple. (probably silver maple, but not sure.) It was about 24" in diameter and I got two 22 inch lengths which have been cut in half pretty much through the pith. They came down a week ago and are beginning to crack at the pith.

How's the best way to saw them up to take advantage of the figure. The area without the ambrosia markings are pretty bland.

I have 3 half logs to go.

Suggestions?


img

Re: How best to saw ambrosia maple logs

#2

Re: How best to saw ambrosia maple logs

Charlie Anderson

Here's what I did with the first log.


img

Re: How best to saw ambrosia maple logs

#3

Steven Antonucci

The problem with big wood...

steven antonucci

Is that if you don't process it, it almost always splits because there is so much surface area and it's hard to control evaporation. I also find that I have to take out a much larger slab in the center to minimize checking.

When I get a log that large, I try to make half of it bowl oriented and the other half end grain oriented. This gives me a bit of variety, and I can always reorient things if I get a check through the sealing.

When I get ambrosia maple, the middle is usually pretty bland, so I tend to get shallower in my blank anyway, and I try to make the inside of the bowl land in the best streaks vs. "as big as I can get".

2 cents

S

Re: How best to saw ambrosia maple logs

#4

Re: The problem with big wood...

steve worcester

Look at the top of the log and try to orient the two halves so the annular ring spacing is fairly even on both sides. Then I would mark a section, a swath, out of the middle on both sides of the center (pith) and make those two cuts. Of course, this depends on the intended usage, as this is for bowls and other usage may determine more cuts, but that is my generic statement for most any logs.

Re: How best to saw ambrosia maple logs

#5

Re: How best to saw ambrosia maple logs

jim miles - Charlotte

Maple deteriorates outside quickly. Leave some of it outside and in 6 to 12 months it should pick up a lot of colorazation and even more character

Re: How best to saw ambrosia maple logs

#6

Re: How best to saw ambrosia maple logs

Charlie Anderson

Thanks guys.

Steve, that's what I did with one of them before I saw your post.

I still have two to go but have plenty to turn right now!