Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Veritas - Innovation in Tools

Finish for Ambrosia Maple?

Posts

Finish for Ambrosia Maple?

#1

Finish for Ambrosia Maple?

Barry

I turned a small bowl from some exceptional Ambrosia Maple this morning. I normally finish Ambrosia Maple with a couple of coats of Deft or lacquer. What is the finish of choice for Ambrosia Maple? What about those beetle holes? I usually blow the dust out of the holes and leave 'em be. Is that what you do?

Re: Finish for Ambrosia Maple?

#2

Re: Finish for Ambrosia Maple?

Steve Criscenzo

If the bowl is intended to be functional, I usually put a coat or two of a penetrating oil such as Watco or Minwax Antique Oil, and then buff but do not wax. If the bowl will hold food I fill the holes with thick CA and either saw dust or coffee grounds so the holes do not become incubators for nasty things.

If the bowl will be more for show I will sometimes add the wax in the buffing series. I find that a penetrating finish on figured wood gives it some "depth" and highlights the figure rather than a finish applied to the surface. The tight grain of Maple works particularly well.

Photo is of a recent post. Two coats of natural Watco and then buffed. result was a very smooth but not glossy finish.

Steve


Re: Finish for Ambrosia Maple?

#3

Re: Finish for Ambrosia Maple?

Barry

Thanks.

Re: Finish for Ambrosia Maple?

#4

I prefer to use a clear finish like ....

JamieDonaldson

..lacquer on Ambrosia, so that the wood stays white rather than the yellowing from oil finishes. Wipe on and rub in a base coat of lacquer thinned with some acetone, used as a sanding sealer, and the chatoyancy will be just as deep as a surface oiled and then finished.

Re: Finish for Ambrosia Maple?

#5

Re: I prefer to use a clear finish like ....

Barry

I may try that. This blank is especially white and I'd like to keep it that way. Thanks.