Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

ADVERTISE HERE - FREE TRIAL

Jam chuck with no curve

Posts

Jam chuck with no curve

#1

Aage Rendalen

Jam chuck with no curve

Aage Rendalen

I began to rethink jam chucks for natural edge bowls after I discovered than none worked better than my Oneway no 3 jaws with a leather patch over it. Usually I'd get a bit of wobble when I'd remount a bowl on a jam chuck with a traditional curve. So I cut off the nose of a couple of my wooden chucks when I was back to my normal jaws. Same result. Hardly any wobble at all. When I think about it, it's no big surprise. You'd have to be lucky to get an identical curvature on chuck and bowl, and when you don't, your bowl rests on one point of contact only. When you cut off the nose, you maintain contact with a larger circle. You'll see one of my small jam chucks still on the lathe in these pictures. Obviously, this wheel has been invented before, but it was late coming to me.


Re: Jam chuck with no curve

#2

Leo Cuellar

Re: Jam chuck with no curve

Leo Cuellar

Good tip and timely for me. Nice little cedar bowl you've got going, Aage. Just had some friends offer me some apple wood from their small orchard.

Re: Jam chuck with no curve

#3

Re: Jam chuck with no curve

Terry Scott

Id have a dozen of these in differnt sizes that I have glued on closed cell rubber with a hole down the middle so I can use the vacuum as well.

I must store them in the same place though or I never find the size I wont and end up making another only to find the same sized one an hour later