Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

100+ Wood Species + Full-Shop Services: Lumber, Veneer, Tools & CNC. Everything in One Place.

Trash can cyclone

Posts

Trash can cyclone

#1

Trash can cyclone

Ken

I have a trash can cyclone that works great but, it leaks around the 4" hose connections. There are lots of results on a Google search but they all address a seal at the trash can. Has anyone here sealed the hose connections? Or have suggestions on how to do it? Thanks for any feedback.

Ken

Re: Trash can cyclone

#2

Duct Tape

Dick Wilson

Re: Trash can cyclone

#3

Dick Hines

Re: Trash can cyclone

Dick Hines

I cut the holes in the lid so I could imstall 4" couplers. Then pop riveted then into the trach can lid and then sealed then with caulking.. No more leaks.

Re: Trash can cyclone

#4

JL

Re: Trash can cyclone

JL

Way back when I built my trash can cyclone, I caulked the "seam" between the PVC fitting and the metal lid. I cheated though - I used a 30 gallon drum with a flat lid.

Re: Trash can cyclone

#5

Re: Trash can cyclone

Jim Sebring

I use quick disconnect fittings, since I use the DC on several different machines. I epoxied the male parts to the cyclone inlet and outlet points. The hose that connects to the DC (outlet) is permanently hose-clamped to one of the fittings. The other (inlet) side is where the hose from each machine, in turn, is attached. I got the QD fittings at Rockler. They're just a tapered push-on fitting and work very well.

Re: Trash can cyclone

#6

Re: Trash can cyclone

pete labelle

Buy a couple 4" couplings. Insert half into the hole. Cut some wood spacers on at least 2 locations and thru bolt with some small bolts. Caulk with silicone. Mine has been working for 15 years now.

Two other tips:

1) Cut a 1" wide slot top to bottom, stopping short of the bottome & top by about 3". Cut a piece of 1/4" polycarb about 3" wide. With bolts every 3" on both sides, fasten the window to the inside of the can, then caulk with silicone. This is your sight glass to determine how full the can is. Once the can reaches about 2/3 full, empty it. Running fuller than that will cause more material to head to your DC bags. I'll empty my can 20 times for each bag change.

2) If not present from the factory, install a 2" wide strip of 1/2" thick foam to the sealing surface of the lid to the can.

Pete