Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Compare cordless drills on the numbers that matter

I am starting to like my new toys

Posts

I am starting to like my new toys

#1

I am starting to like my new toys 

Terry Scott

When turning I am continuously trying to improve my finish off the tool

This piece of Australian hard desert timber (yes the name was written on the blank but I forgot to note it down before the name went to saw dust Dam blast )

As I was turning one of my winged pieces the timber was being turned cross grain .

I was struggling a bit as I was getting allot of torn grain and this was causing chatter as the hit and miss soft hard grain

So I sharpened up my largest kelton hollower with a high prominent burr(pour tip will never be the same )The best cut was as shown with handle up in the air and the tip cutting below center almost at the point of the tool being cutting on the down ward stroke.I can hear the oh my god whats he doing.Dont worry I was in control not the tool

The stiffness of the tool enabled me to cut to 2mm 1/8 .Probably an over kill on a small box but I was just using a stroking cut and taking off the minimum I could

The next shot is showing the shavings not from the Kelton but a tool tip I have come up with (no you cannot see it l.o.l )as hopefully a tool manufacture will shortly be making them

I was surprised at the finish cleaned up like a babies bottom . Sanding with 120o wet and dry with oil was all that was needed.

I also found that the speed increased got a better cut about 1200 rpm

Tomorrow I will start on the lid and finial

Cheers

Re: I am starting to like my new toys

#2

Re: I am starting woops wrong photos 

Terry Scott