Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Have a question? Ask Woody!

powermatic 4224 digital display

Posts

powermatic 4224 digital display

#1

powermatic 4224 digital display

HeatherAinAK

Hello, I just got done replacing the spindle on my powermatic 4224. The digital display never worked correctly. It showed the speed until around 1400-1700 rpm then went back to 0 or bounced around with low numbers. Now that I have replaced the spindle it always reads 0. There are 4 little pins on the spindle that are positioned like spokes that run near what I think is the speed detector. Did I put something back incorrectly? All I have is the parts diagram which is less than helpful. I know I do not really need the digital display but it bugs me.

On the bright side it runs like a dream with the new spindle! The old one was too long and none of my chucks seated down on the shoulder so the chucks wobbled. I was fussing about it and my husband sneaked around and ordered a new one.

Thanks,

Heather

Re: powermatic 4224 digital display

#2

Re: powermatic 4224 digital display

john lucas

Heather this is just a guess because I haven't seen the spindle. It could be the sensor (if there is one) is too far from the spindle. I don't know if there is a sensor or if there is an adjustment for it but in my experience with other things the distance is fairly critical.

Re: powermatic 4224 digital display

#3

Re: powermatic 4224 digital display

HeatherAinAK

Thanks John, I got it working last night and that was exactly what was wrong. I spent several minutes turning it up and down watching the numbers change!

Heather