Galen, here's a few answers. George a couple tooo *LINK*
Greg Haugen
Depending on what you want to turn, how you cut the log will matter. One thing that is always the same, you don't want the pith, or anything too close to it. If there's a few "splits" off of the pith, don't worry about it, those will be cut off by staying clear of the pith.
The easy answer is for end grain pieces (spindles, hollow forms, vases), it doesn't really matter. You can incorporate some "sap" wood color if you'd like but it's not that crucial. Stay away from the pith. If I'm cutting for end grain pieces, I'll still cut it often times like I'm bowl blanks, cut of a big of the bark side and cut down the middle about an 1 inch or so from the pith. From there, I'll take that slab and cut squares out of it. Usually getting two or three "blocks" per slab. If you're going to work it soon, you can just 1/4 a log, again avoiding the pith. I usually do the "slab and then square" method just to avoid turning a bunch of bark off later. I'll seal the ends and get to them later. Before I turn a "squared" block, I do tilt my bandsaw at 45 deg. and take off the corners. Especially if it's 6" or thicker. Makes the initial turning a little easier.
If you want to do a few bowls or plates, you're better off centering the pith, aka "balancing the grain", for each cut. Looking at George's log, There's "lobes" to the diameter of the log, the two that are on the back side are fairly balanced on the pith, and the third (in the front), though it's small, would be a great natural edge bowl or vessel. John Jordan talks about "balancing" the grain in his "Aesthetics" DVD, I'd highly recommend it. If the grain is balanced in a bowl and platter, it will help in the drying process since the "tensions" will be a lot more equal, it will also add some "effect" and symmetry. Production turners will bend this rule a bit since they're after quantity and size as well.
Here's an example of when I'd "scrap" a half. "limb" wood will have the pith off centered, majorly. IF you balance the grain, one side will be real thin and one side with be real nice and thick. I'd take the thick side, and possible scrap the thin side-if it's too thin. I wouldn't cut this in a manner where the two side are equal. Tight grain and loose grain will be in the same blank and it would be problematic.
The only logs I leave alone are the ones with "shakes". Splits that go with the growth rings. Looks like a separation of the rings. Cracks can be cut out easily, but "shakes" can go a long distance. It's just not worth it. If one side has a shake and one side doesn't, I'd take one side and scrap or burn the "shaked" side.
I use anchorseal to seal the end grain of pieces, unless I'm going to cut them that day. It's worth it.
George,
I agree with the others. I use a chainsaw for "log" work and a bandsaw for "block" work. But if you cut that on the flat end, like it is, you'll be fine with a bandsaw. Do not lay on its bark and try it. If not, find someone with a chainsaw. You could also split with wedges, but saws are my preference.
Enjoy. Mesquite is a great wood.
John Jordan's Page for Tools and the DVD