Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Identify and use hundreds of woods

Platters

Posts

Platters

#1

Platters

Tomm

I have had good luck rough turning bowls using wet wood and then drying for a month before finish turning, but I was wondering if it would work with large 15" platters. Has anyone tried roughing a platter from wet wood and then finishing it later after it dried? Thanks for your thoughts.

Re: Platters

#2

Re: Platters

adrien

That would seem to be the way to go. Finish t

urn it green and when it's dry it'll be too wavy to use.

Re: Platters

#3

Re: Platters

Phil Joines

I don't "turn" them, just rough them on the band saw.

Re: Platters

#4

Use dry blanks

Jorge Casta�eda

and your life will be easier.

Re: Platters

#5

Re: Platters

Greg Haugen

In my opinion, the thickness of 2" or slightly thinner is the point where I decide to rough out or leave as is. I've built a kiln out of an old upright freezer and can dry out rough outs or "blanks" in about the time frame of 1" per month. So in other words if I rip some 2" or thinner slabs, I'll seal the endgrain and put them in the kiln for 2 months. If I'm in a rush, I'll rough it and shorten that time.

I like to use "green" wood compared to kiln dried blanks that are cut from a board. I have a lot more control over the orientation as well as figure. I have stacks of figured walnut and figured ash, for a little bit of time with a chainsaw. You'd have a difficult time finding this kind of figure out of a board, you it would cost an arm and a leg.

If you don't have a kiln built, seal them and let them sit like you would a bowl.

Re: Platters

#6

Re: Use dry blanks

Barbara Gill

The nice thing about making platters and plates isnthatnyou can use a dry board or plank. I agree with Jorge. I always use dry pieces of wood.

Re: Platters

#7

Peter Charles Fagg (UK)

Re: Platters

Peter Charles Fagg (UK)

I have been turning platters for nearly 20 years thats why I call my business "Peters Platters"!

I have attempted to turn Green wood platters but found that although the idea sounds OK the timber moves too much during drying and unless the thickness is left over thick there is no leeway left for finishing.

In my order book right now are 2 orders for platters of 15 inches and one I am sourcing timber for at 30 inches x 2 inches. They will all be made with kiln dried timber because time is of the essence.

If you decide to go down the Green road I would be interested to know how you fare!

Regards Peter.

Re: Platters

#8

Re: Platters

Phil Powell

I always turn platters and almost everything else green. I have 8 acres of woods

and it's mostly green. Platters aren't that different from other forms so why

not? Here's a photo of several 16 to 19 inch roughed out maple platters waiting to dry and return.