Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Portable Sawmill & Tree Service – Abingdon, VA

EpoxyIssue & Tip

Posts

EpoxyIssue & Tip

#1

EpoxyIssue & Tip

Mark Mandell - Gone Round In Jersey

I've been using System 3 epoxy to fill voids for a number of years, but have run into something new. While filling voids with very small cracks in some flatwork boards, I added 5-10% DNA to lower the viscosity and get better penetration [an accepted practice]. What I got was epoxy literally foaming out of the sections with the remainder spongy and worthless. Contacted System 3 and found out that what was happening was that the alcohol was actually boiling [170�] in the mix due to the chemical reaction heat during set. This can also happen with wet wood as the reaction temp can reach 212� so that steam is generated.

If, therefore, anyone here is having issues with porosity in epoxy infilled areas, the steam may be your problem. Remedy is to keep things cool. You get a slower set and cure, but more solid plastic. If you have fine detail to fill, use a prethinned epoxy and/or heat the mix to just warm to thin it out and get it to soak into small spaces. It's also good to put some vacuum on your mixing cup before you pour the mix to get entrapped air out of the liquid.

m

Re: EpoxyIssue & Tip

#2

Re: EpoxyIssue & Tip

Bob Edwards

Will acetone do the same thing? Boil that is! Was there any water in your DNA?

Re: EpoxyIssue & Tip

#3

Acetone

Mark Mandell - Gone Round In Jersey

Boils at 133� [much lower than alcohol's 170�] so I think the safe answer to your question is "yes".

Don't know if there was water in the alcohol, but since the alcohol boils first, it wouldn't matter, as the damage would already be done.

Re: EpoxyIssue & Tip

#4

Re: Acetone

Bob Edwards

I asked because I have tried both and not experienced the "boiling effect" you described. I was not using System 3 but a two part epoxy used by model makers. I do however thin the epoxy first than add the hardener. Don't know why that should make any difference.

Re: EpoxyIssue & Tip

#5

Jesper, Denmark

Re:Ethanol does not boil first.....

Jesper, Denmark

It is really irrelevant, but the water and ethanol fprm an azeotrope and boil together at a slightly lower temperature than the BP of 100% ethanol in the ratio of 95% ethanol and 5% water.

The heat from the exothermic reaction between the two components has to go smewhere, so if the epoxy mass is too bulky, it cannot get away, and the temperature gets too high. This also happens in unthinned epoxy if the heat cannot get away. If you mix 8 ounces of epoxy, and forget it in the mixing cup, it will get hot and foam rather quickly too.

DAMHIKT