Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Need a tree taken down or milled?

Life's lesson # 243

Posts

Life's lesson # 243

#1

Life's lesson # 243

Scott Hurley in N VA

Never use Anchorseal on a roughed-out bowl blank that has a bark inclusion. Now I can't seem to get it out of the little crevasses in the bark. I've tried mineral spirits and a hair dryer (not together), and a dental pick, but I still can't seem to get it out. Does anyone have any suggestions? Thanks.

Scott

Re: Life's lesson # 243

#2

Jim in Burlington Ont.

Lemonade

Jim in River Oaks, Ont.

Thinking , "What will dissolve Anchor-seal" Maybe gentle heat? (hair dryer etc).

Sand blasting also comes to mind, but it might be a "lemon Problem" now, perhaps lemonade has become an option, you might think of using it as a design enhancement opportunity?

Take care.

Jim

Re: Life's lesson # 243

#3

Re: Life's lesson # 243

Mark Mandell - Gone Round In Jersey

Anchorseal is a wax emulsion. The water dries leaving the wax coating behind. It also leaves the emulsifier behind.

You can remove the remaining Anchorseal by running the surface under hot water. The wax will just rinse away.

Note: Do not use regular Anchorseal on wood that will be rained on. A couple of good soakings and the "sealer" is gone.

Re: Life's lesson # 243

#4

Re: Life's lesson # 243

woodspinner

Mark is right, water will get it out. If there's any left I use a battery powered tooth brush works great for getting wax out of bark and any other rough spots been doing it for about 10 years now.My NEW one is Buzz Lightyear now he has some power.$5.99 at Wally World.

Re: Life's lesson # 243

#5

Re: Life's lesson # 243

Scott Hurley in N VA

Thanks for the quick answers. I'll try the hot water, and probably an electric toothbrush.

Scott