Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Nearly 100 Exotic Wood Species, Direct-Imported Since 1972. Shop Slabs & Turning Stock.

Sanding Drill Problem

Posts

Sanding Drill Problem

#1

Sanding Drill Problem

Stuart Johnson

The other day I was power sanding with a Milwaukee right angle drill. I blow the dust off with compressed air (about 90 lbs maybe more) between coats. I decided to give the drill a squirt or two and blow out the dust. The drill no longer works. For all that happens it might just as well be unplugged.

I've taken it apart and all looks okay. There are no loose wires and the brushes look to be fine. Any ideas about what happened, how to trace the problem or fixes?

Re: Sanding Drill Problem

#2

Steven Antonucci

Have you checked the switch?

steven antonucci

My first, best guess would be that you blew dust into the switch, and that it can no longer make an electrical connection. If you can pull it out, a meter will confirm this.

S

Re: Sanding Drill Problem

#3

Peter Charles Fagg (UK)

Re: Sanding Drill Problem

Peter Charles Fagg (UK)

My sander went haywire after I had applied a vacuum cleaner nozzle to it, I had to remove the brushes and clean the commutator before it worked again! (I used Methylated Spirits, don't know if that is available in the USA)

Might help, regards Peter.

Re: Sanding Drill Problem

#4

Re: Sanding Drill Problem

bill Crommett

That is why I buy a $30.00 throw-away from Big Lots for sanding. They have the quality I require --- they run until they stop.

Re: Sanding Drill Problem

#5

Thanks the switch was it or

Stuart Johnson

the electric gods took pity on me. I couldn't tell what the switch was doing but in the process of messing with it and blowing out any dust that might be in there I disconnected a couple wire and reconnected them when I put it back together. The switch itself is pretty sealed so I don't know what fixed the problem but it's running.

Re: Sanding Drill Problem

#6

Steven Antonucci

Assumed it was electrical

steven antonucci

I have a second switch on my lathe that often clogs with dust. I don't know how it gets in there, but it does. Took me days to figure it out, so now I assume that every "dead" device is because there is dust insulating current somewhere...

Glad it's fixed.

S

Re: Sanding Drill Problem

#7

Re: Sanding Drill Problem

woodspinner

Got a right-angle from Harbor Freight 2 years ago it's slow speed and does wonders as a sanding drill.

Paid $19.95 and it had a 90 day warranty can't beat that.

Re: Sanding Drill Problem

#8

Re: Sanding Drill Problem

Barry

The price of Harbor Freight's right-angle drills is now inflated to $29.95 and $39.95. The higher priced model has a keyless chuck. Both appear to have decent quality. I looked at a Milwaukee right-angle recently and was not impressed with the quality. I say buy the cheap throwaways and run 'em 'til they quit, then toss 'em.