This Week Has Been Crap!!
Dick Wilson
It is Friday and I see now that I should have taken a vacation this week.
I started out the week turning an hourglass for a suspended form I am doing. I got it hollowed out on both ends. On Wednesday I was turning down the very thin middle and in Wilson fashion blew it off the lathe. I decided to do some airbrushing and discovered that the set screw holding the tip was missing. Found it promptly on my spic and span floor. Right! Took a trip to Lowes to get another one and my dog barfed on the front seat while I was in the store. I called it a day
Yesterday I rough turned a new piece for my hourglass. But my airbrushing turned to crap so I had to start over on that piece. Today I was hollowing 1/2 of the hour glass and went through the wall at the bottom
What is even more infuriating is I was too stupid to use my laser light

Can someone tell me how much it costs to get into chip carving? Of course, in Wilson fashion I would probable forget to put on the glove on and would lay my whole hand open 
Oh well, there is always next week






