Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Support WoodCentral when buying things you need

Holding small parts.

Posts

Holding small parts.

#1

Dick Hines

Holding small parts.

Dick Hines

I saw a cool way to hold small parts in a chuck that the jaws will not clamp small enought.

Thae 4 short wooden rods and rubber band them together. Then put your small piece between the four rods and clamp the whole thing into the chuck.

Works great.

Re: Holding small parts.

#2

Re: Holding small parts.

fgvanatta

I like it - will have to try that.

Frank

Re: Holding small parts.

#3

Re: Holding small parts.

Jim Rutten

For those of us who are visual learners as opposed to audio learners, would you mind providing a picture?

Re: Holding small parts.

#4

Dick Hines

Re: Holding small parts.

Dick Hines

I did have a camera so no pictures.

Just picture in your mind. 00

0

00

The circule in the middle is the small piece your are trying to hold.

Re: Holding small parts.

#5

Re: Holding small parts.

charlie belden

Or you could chuck up a section of dowel the chuck will grip,

drill a hole in the end the diameter of your small part - and use it as a jam chuck

Re: Holding small parts.

#6

Dick Hines

Re: Holding small parts.

Dick Hines

The dowel was 1/4" I don't know of a chuck that will close down that small.

Re: Holding small parts.

#7

Re: Holding small parts.

charlie belden

But a set of jaws that will hold a 3/4" dowel - with a 1/4" hole drilled through it - the 3/4" dowel with two saw kerfs in it - works - honest.