Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Fast and affordable laser cutting – so you can make the parts you can’t find anywhere else

WAY OT: Removing Cement from subfloor

Posts

WAY OT: Removing Cement from subfloor

#1

Steven Antonucci

WAY OT: Removing Cement from subfloor

steven antonucci

A while back, I posted a shot of some water damage in my sunroom. I removed all of the tile flooring, and I am going to lay a wooden floor over it. There are small bits of cement that probably need to go before I put the other floor down.

Far too many to just mash with a hammer. I am looking at leaving the subfloor as close to perfect as possible.

Anyone got tricks for getting cement to separate itself from plywwod?

Steve

Re: WAY OT: Removing Cement from subfloor

#2

Re: WAY OT: Removing Cement from subfloor

Stuart Johnson

Try using a very stiff putty knife and see if it will pop off. If it will then I would go to the borg and buy a tile scraper. It's basically a wide very heavy blade on a long broom handle type pole. If you want to swing by the house you can use mine. If that doesn't work give the kids each a hammer and $2.00 a square foot to smash them.

Re: WAY OT: Removing Cement from subfloor

#3

Re: WAY OT: Removing Cement from subfloor

Bill Turpin in WNC mountains

Buy a gallon of distilled vinegar. Give the cement a quick soak. Might not work, but it is safe and cheap.

Re: WAY OT: Removing Cement from subfloor

#4

Re: WAY OT: Removing Cement from subfloor

Thad Parker

I'd try a square shovel.

Or consider that it may be less work to pull up the subfloor and flip it over, making sure there's not significant cement where it rests on the joist.

Re: WAY OT: Removing Cement from subfloor

#5

Re: WAY OT: Removing Cement from subfloor

Barry Irby

If a manual scraper doesn't work for you, you might try a floor sander with course sandpaper.

Re: WAY OT: Removing Cement from subfloor

#6

Re: WAY OT: Removing Cement from subfloor

Toney Robertson

Sidewalk scraper. Long handle so that there is no bending over. Get the heavy welded head. You can actually sharpen it if necessary.

It should not take you long.

Re: WAY OT: Removing Cement from subfloor

#7

Re: WAY OT: Removing Cement from subfloor

robo hippy

No easy way to do it. The scrapers (we used to call them spud sticks, no idea why) may get up a lot of it. The vinegar will dissolve the cement, but not sure how long it will take. You could get a grinder (grinding wheel, not sand paper) which will be very dusty. A few light whacks with a hammer (hammer face flat to the floor, not hitting with the rim/edge) will soften it up a bit and maybe make it easier to scrape off. Getting it off is kind of like keeping bark on natural edge bowls: If you want it to stay on, pieces or all of it comes flying off. If you want to take off, only about half of it will come off. Worst case could be that you need to skim coat the surface with more cement/mortar mix.

robo hippy

Re: WAY OT: Removing Cement from subfloor

#8

Leo Cuellar

Elephant in tap shoes????

Leo Cuellar

Re: WAY OT: Removing Cement from subfloor

#9

Re: WAY OT: Removing Cement from subfloor

Mike Brazeau

This is absolutely one of the worst jobs in renovating. We paid about $4 sq.ft to have ceramic tile and the mesh removed as well as most of the staples on about 500 sq.ft. The hired guys used a heavy bar with a 2" chisel nose. Absolutely brutal work. I then spent about three days pulling it seemd like thousands more staples and prepping the plywood underlay for hardwood. I used 40 grit paper on a Random Orbital Sander to which I had attached a vacuum hose to smooth out the small bits and the plywood damage due to the hammering and chiseling. A wide heavy chisel and hammering was the most effective way to get up small bits. You should also probably rescrew the underlay because of all the abuse it has taken. The end result was great, but getting there not an experience to have again. I have also removed ceramic off concrete and used an angle grinder with 25 grit disks to get the residue off it. Extremely dusty!

Re: WAY OT: Removing Cement from subfloor

#10

Steven Antonucci

Thanks for the ideas

steven antonucci

I didn't know about the vinegar and cement thing. I'm probably going to start here with a small test area. I'm not in a great deal of hurry, so if it takes a day or a week, but happens "by itself", I'm good with that.

I started with the hammer when I first pulled the floor up. Not happening. Between the noise and the effort, I'd rather skim coat the whole floor than chip it.

Besides, I just filed all of my hammer faces clean for metalwork :)

Thanks

Steve

Re: WAY OT: Removing Cement from subfloor

#11

Spud

Jorge Casta�eda

Not a potato, but a bark spud, the tool Robo Hippie was refereeing to, originally meant to take the bark of logs, mounted on a long handle will do the job, and ice breaker will too, but is easier to get the job going with the spud, a combo of both may be your best bet.

Can post pictures of both...

Nasty job!

Re: WAY OT: Removing Cement from subfloor

#12

Re: WAY OT: Removing Cement from subfloor

John Altberg

Steve,

We were faced with the same problem in our kitchen. We removed the ceramic tile so that we could put radiant heat mesh under new ceramic tile. Removing the tile was the most brutal job I ever have done, BTW! We were left with sub-floor with lots of thinset (cement) stuck to it. After much scraping, chipping, grinding, swearing, etc., I was ready to pull up the sub and start fresh. My wife suggested that I rent a floor sander, to which my immediate response was, "That won't work!" As usual she was right. Got a big floor sander/polisher from the tool rental shop as well as discs that they said were 5 grit! Ate through the thinset like butter and left a suitable finish on the sub-floor for the heat mesh. Created a hell of a lot of dust, but we finished the job in under an hour! Good luck!

John

Re: WAY OT: Removing Cement from subfloor

#13

Boiling Water?

A. Kapocius

Re: WAY OT: Removing Cement from subfloor

#14

Another thought.....

Barry Irby

I removed a bathrooms worth of ceramic tile with an SDS hammer drill in short order. They make a chisel for them designed to do this. Bathroom was about five by eight, but only took about forty five minutes. Turned out great, but not something I would volunteer for again. Sort of an electric spud. They also make a machine for removing vinyl tile. You can rent one. Might work.

Re: WAY OT: Removing Cement from subfloor

#15

Steven Antonucci

A quick test reveals...

steven antonucci

That a little vinegar on the cement makes a hammer much, much more effective. With a three day weekend coming, I will be painting the floor on Friday night with vinegar, and hopefully waking up on Saturday AM with a hammer and some ear plugs ready to go...

Who would have thunk it?

Steve

Re: WAY OT: Removing Cement from subfloor

#16

Re: A quick test reveals...

Bill Turpin in WNC mountains

Be sure you get distilled, WHITE vinegar. It's acid content is a little higher than apple cider vinegar. Acid content is regulated to make safe canned foods. Keeps out botulism in tomatos, etc. Or is it tomatoes? We do not want food poisoning in your sub-floor!

Re: WAY OT: Removing Cement from subfloor

#17

Steven Antonucci

Distilled White it is!

steven antonucci

I had been working in there (it's one of the rooms I use as my home office), but the smell kept making me want a salad. I suspect that I can coat the floor, and finish the demo in a day, and then give it a few days to dry out.

Thanks for your help

S